Average Repair Rating: 2.3 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Oven would not turn on
Checked the microwave door latch and it seemed to be okay. Removed the control board cover and the start button seemed to be worn so I ordered the new cover. delivery was fast (1 day) but it arrived without the control board/number overlay. I was told that those were sold separately. this is a little irritating because there is no way to
... Read moretransfer those from the old cover to the new as they are firmly glued to the cover and cannot be removed. I feel the cover should be sold with those 2 items included. I ordered the extra items and they arrived quickly as well, but I had to again pay for the shipping. (this could be avoided if they would just state up front that these are needed). I assembled the cover and re-installed. Pushed the start button and it did not start. I opened and closed the door 4 more times and then discovered the latch mechanism had actually broken. I removed the inner door cover (used 4 screwdrivers and worked it off the door carefully so as not to break the cover) and found that the flimsy extra-cheap support that holds the spring tension had broke off. I found a suitable area below the support that broke to drill a tiny hole and install the spring tensioner. Re-assembled the door, closed it and low and behold everything worked again. Lesson learned.
Read less
Jim from PALM DESERT, CA
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers
1 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jim
August 15, 2017
Any special install instructions and is this part the whole panel?
For model number FGMV174KFB
Hello Jim, thank you for contacting us. There are no special instructions to install this. It is just the cover housing, no buttons or electronics. The touch pad with the numbers on it is part number is PS2369349. The touch control board is part number PS2369351. Hope this helps!
I have a sagging door that is preventing my microwave from coming on. I cannot find any screws to adjust or make any other adjustment. Can it be fixed?
For model number FGMV174KFB
Hi Thomas,
Thank you for your question. If the microwave door is sagging and the problem is at the top of the microwave, the door stop will need to be replaced. The part number listed under your model number for the door stop is PS2343169. If it is sagging from the bottom, the door will need to be replaced. The part number listed under your model number for the complete door assembly is PS2369380. We hope this helps. Thank you and have a great day!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
