http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/54089.gif
See part 5 in the diagram

Door Latch with Switches - NO Handle

PartSelect Number PS2367344

This is the door latch and switches only. The handle is not included with this part.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Door latch failed.
  • Door won’t close.
  • Will not start.
  • Compare At

    $30.11
  • You Save

    $5.02
  • Your Price

    $25.09
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Videos For installing this part.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.1 / 5.0, 68 reviews What's this?
 

1 of 3 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyA Bit Difficult

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerRalf from Manchester TN

Door would not lock

I called for a Lowes where I purchased the dishwasher was told it was out of warranty, they set up for a repairman to come out and fix it. He came out and told me it would be $190.00 for parts and labor but that didn't include the service call of $60.00 dollars. Total bill would be $250.00, plus it would be another 2 weeks before he would be able to get back because he had to order the part but and get this I would get the part delivered to the house before the two weeks, and that he wouldn't guarantee the part for more then 90 days.
I told him no way, so I researched the internet and found this site part cost $25.00 dollars my time about 30 min. SAVINGS of $225.00.
The part was pretty easy to install had to take out a few screws around the edge. Only trouble I had was putting in the handle but I figure that out and put everything back together again.
I would purchase parts from this company again had it within 2 days, at a very reasonable cost.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

ToolsNutdriver, Pliers, Screw drivers

CustomerLloyd from Denver NC

Unit would not turn on.

After checking the door switch I found the micro switches were working but the unit would not start on the control panel. Thinking the latch was worn, I ordered a replacement. After changing the replacement latch and switches that came with it, the unit would still not start. I checked the switch and it is making contact. I can start the unit after I close the door using the handle of a pair of pliers. So I assume the control board is bad, due to the fact that it will not initialize the control panel until the door is closed. Now I have ordered a control board and will replace...stay tuned!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerMandy from Lafayette CA

Door would not close - latch broken

1. Turned off power. 2. Unscrewed ten screws holding inside of door in place. 3. Lifted cover enough to access latch - helpful to have someone to hold this while doing the job. 4. Disconnected old latch assembly on each side - this was the hardest part as they were stiff and needed to be pulled hard. 5. Attached new latch assembly. 6. Screwed door panel back on. 7. Switched power back on. So easy and saved about $150. This stuff is NOT HARD and I just wish more people had the gumption to do repairs themselves instead of paying 'experts' to do exactly the same job.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

Customerpeter from redondo beach CA

Door det not lock

Replase door lach Thang you for the fast respons Peter Hansen

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver

CustomerEduardo from Whittier CA

Plastic part was worn out

the small plastic part that turns the dishwasher off and on when the door is shut was worn out. It was really easy to change out. I unplugged the power cord and removed the black and white wires. Put in the new switch and it was ready.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver, Pliers

CustomerJason from Edmonds WA

Broken latch

Upon noticing that my latch was broken I removed the 10-12 torx scres from the inside of the front panel. After lifting up the inside panel, I removed the two floats from the latch assembly. I did not turn off the power at the breaker but did get a few volts in removing the float switches. When I received my parts, it took about 15 minutes to reattach the handle kit to the front panel and seal up the door. I did turn the power off at the breaker so there was no issue in stalling the wires and float switches to the handle assembly. I di order both the Latch and Latch Assembly that was shown in the picture without the latch. I was happy to see the latch already atteched to the latch assembly and I have sent the latch back for a full refund. Easy assembly and install.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsPliers, Screw drivers

CustomerRobert from Blue Bell PA

Easy fix for a broken door latch

Removed the screws that attach the inside of the door, keeping them in order. Two are longer. The part is loose at that point and the wires un clip with a little pull with a needle nose. Replaced with the new part, re screwed and good as new. oh and turned off the breaker before disassembly.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerUlrich from Desert Hot Springs CA

Could not open door

Remove all screws on inside panel disconnect wires remove switch

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerMark A from Springtown TX

Broken door handle

unscrewed interdoor to expose harness. Replace
handle assembly.
Very easy to do and very satisfied with new part. I ordered 2 parts to make sure I had the actual one with door handle release. One of the assemblies came without the actual handle but at least if I have a switch problem I will have the Harness and switch assembly.

Happy Camper

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers

CustomerMark from laguna niguel CA

Latch handle broken

the removal of panel was simple, the removal of electrical connections was difficult even with a little wd 40 i was nervous when any metal part is attached to a plastic part. it didn't want to let go but my suggestion is to work the connecter back and forth forward and back to get it started then with a firm grip on the wire harness with pliers pull the two apart with pliers. good luck!!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerRG from St Simons Island GA

Latch had broken off inside

removed all the torx screws that hold the inside panel to the door. Removed the latch/switch.[Don't forget to turn off the power] Could not remove the wiring harness from the micro switch so I removed the old micro switches from the old switch and moved them to the new switch, harness and all. repositioned the latch and reattached the panel.
there are two latches available. I ordered the wrong one at first. Got the correct one in just two days. Was able to return to wrong one for credit.
Great service. Glad I didn't call a repairman.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerRon from Roanoke TX

It was too easy.

Matching the part I had in my hand with the picture online was a cinch. Rec'd the latch in a few days, and installed it in minutes. Why did I wait so long to look it up and order? At least the kids think I'm a hero for fixing the dishwasher!

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsPliers, Screw drivers

CustomerMarilyn from Pauma Valley CA

Latch was broken

I removed the screws from the door, popped out the broken part, installed the new door latch and replaced the screws. The repair was fast and easy. Reading others comments about how to do the repair here helped a lot. Ordering from this company and finding the correct part couldn't have been easier. I feel fortunate to have stumbled upon this website. Fixing this on my own saved me a lot of money. Just for kicks I checked online with Sears. I found the part but they would not let me order it, I would have to request someone to come out and repair it for me, LOL! Thank you Part Seclect!

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Door Latch with Switches - NO Handle

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

Customergeorge from austell GA

Door would not open/latch pivot pin broken.

After prying open the door i removed the inner skin cover which did provide me access to the latch assy,2 additional screws and it was fixed.

This appears to be a problem with this apliance since it has done this before while under warranty

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers

Customermario from pilot hill CA

Broken latch handle

read previous repair reports so that I had a understandingwhat was ahead.
Removed the screws and the handle assembly was right there. Had a problem removing a electrical slip connector from a micro-switch(thus the need for the pliers). Reversed order to assemble....working like a champ.
DO disconnect the dishwasher from its power source.

Help other customers find the most helpful instructions.

Were these instructions helpful?