BBB A-Plus
2365151-1-M-Whirlpool-12656106-Pantry-End-Cap-Left-Side.jpg
2365151-1-S-Whirlpool-12656106-Pantry-End-Cap-Left-Side.jpg 2365151-2-S-Whirlpool-12656106-Pantry-End-Cap-Left-Side.jpg

Pantry End Cap - Left Side

PartSelect Number PS2365151

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Kenmore, Admiral, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Door won’t open or close
In Stock

  • Compare At

    $23.05

  • You Save

    $3.84

  • Your Price

    $19.21
Fast Shipping

Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions

Provided by PartSelect customers like you.

< PREVIOUS 1 2 3 4 5 6 NEXT > 16-30 of 77

 

1 of 1 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsSocket set

CustomerMARIAN from CONNELLSVILLE PA

A piece that holds the door to the meat keeper broke off.

I had to remove the tray that is the meat keeper and the glass plate above it. I then removed three screws and replaced the part with little or no effort. I was able to replace this so easily.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsNutdriver

CustomerErik from Cumming GA

Hinge on 'goumet lid' in front broke off

Wasn't a big deal. Removed the the shelves and glass immediately above the endcap as well as the large 'goumet' draw. Used a nutdriver to remove two screws. Popped off the old endcap and did everything in reverse. Replaced the long clear goumet draw cover that was still intact. Thanks for making it easy!!!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver

CustomerForrest from Aurora KY

Broken lid hinge

Removed three screws and removed endcap LH and screwed sliding shelf bar two new endcap and reinstalled end cap in ref.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerJohn from Altamonte Springs FL

The closure lid retainer tab had broken off of the pantry end cap

First I removed the two vegetable bins. I then removed the glas top shelf from the pantry and removed the pantry drawer. There were 3 screws that held the pantry end cap to the interior of the refrigerator. I removed the three screws. I then lifted up the front end of the end cap allowing it to snap free. I then snapped the new end cap in place and reinstalled the screws. The rest was just reversiing the drawer installations.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyReally easy

Time to do repair:30 - 60 mins

ToolsSocket set

CustomerCirilo from Fort worth TX

Small pantry lid moves on 2 small hooks. One broke

The hook is part of the end cap so I replaced the end cap. The drawers and glass top came out easy. At that point the end cap was removed. It is held in place by 3 screws. Very simple job.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsSocket set

CustomerJennifer from Woolwich Twp. NJ

Plastic pin that hinges the pantry lid on snapped off

First, let me say that it only broke because a teenage house guest that didn't know how to open the lid, yanked on it.

I, the lady of the house, repaired it myself. I took out the wide pantry drawer, the two smaller drawers and 1 glass shelf, unscrewed the glider rail (2 screws), unscrewed the old panel (4 nuts). Put the glider on the new panel, screwed the new panel on, put the shelf and drawers back. No Problem. Thank you.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver

Customerralph from hemet CA

Broken lid holder on left hand pantry door

removed crispersn glass under crispers. took out pantry drawer. removed three hex head screws , and removed pantry door holder.
replaced with ordered part and put everything back together. works great. also gave me a chance to really clean under the crispers.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyReally easy

Time to do repair:30 - 60 mins

ToolsNutdriver, Screw drivers

CustomerWilliam from Eagle ID

The hinge pin on the pantry door broke off.

First I removed the pantry drawer, one crisper drawer and the pantry door. Using a nutdriver I removed three screws holding the pantry end cap in place. Once the end cap was removed I used a screw driver to remove two screws holding the drawer slide mechanism. Installation of the replacement end cap required doing everything in reverse order. The repair went smoothly and took about 45 minutes.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsNutdriver

CustomerJohn from New Port Richey FL

Broke the plastic pin that the meat and cheese drawer covers

First I bought the wrong size left end cap. Then I bought the correct one. Measure and check the size first, learn from my mistake! This is the french door Refrigerator with the freezer on the bottom. So first remove the lift up door and the slide out drawer that is held up by the left end cap. Then, take out the two drawers, the glass shelve and the two front and back brackets that hold up the glass shelf. Then remove the three screws and when they are removed put straight up on the front of the the end cap to release the slide on hold in the very front. When replacing insert the two back tabs and slide onto the hold in the front. Do not over tighten the 3 screws and then replace the two bars, the glass, and the two drawers.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerTony from Rice MN

Kids broke the pantry door and endcap.. poor design

It actually took me longer to find the part then to do the repair. Just removed a couple of screws, removed the door track, put in the new parts and good as new.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerMerrill from Colorado Springs CO

Pantry lid broken, center rail broken, pan corner cracked

Remove broken parts with philips screw driver (6 screws). Replace encaps while attaching pantry drawer lid. Insert center rail and new drawer.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver, Screw drivers

CustomerMark from Saint Paul MN

Broken knob that the draw cover attaches to

Couldn't have been easier. The missus dropped a cabbage on the draw cover, that broke off the knob that holds the drawer cover in place. Doh, this is a fairly new fridge and having to live with a drawer, missing the cover, just didn't work for me. I went on line and found parts select. Withing 10 mins the part I needed was on order, 3 days later I had the part and 15 minutes after that it was installed and the fridge was back together. Couldn't have gone better!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsScrew drivers, Socket set

CustomerSuzanne from Crossville AL

Broken plastic chefs pantry door spendles

First. remove the two drawers and the glass shelf above them. Then using a hex socket remove the two hex head screws that hold the parts to the side of the fridge. Remove the metal drawer slides from the old part and apply them to the new part. If you are installing the left bracket reattach it to the fridge. If you are replacing the right side add the following steps. After attaching the slide to the new part remove the temp control assembly from the old part paying attention to how it fits together. Transfer to new part. Reattach new part to fridge. Carefully reattach pantry door to spindles. The hardest part was taking the temp control off of the old part and putting on the new part. I had made at least 5 calls to the store where I had purchased the refrigerator but I couldn't get them out to repair it. I decided to do it myself and I'm glad I did. It probably saved me at least $50.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers, Wrench set

CustomerGregory from Hooksett NH

Small piece broke off

After removing the shelving in the refrigerator to access the pantry slide out panel I removed the metal sliding rails that the pantry drawer rides on and put them aside. I then used s 1/4" hex socket screw driver and removed the 3 screws holding the part in place. After wiping the area of any moisture from the humidity on the plastic I screwed the new part in place and then attached the sliding rails and replaced all the draws I had removed ealier. Total time was no more than 15 minutes!

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

    • Pantry End Cap - Left Side

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers, Socket set

CustomerEdward from Elk Grove CA

Support stem for llift drawer had broke

It was so easy to install, no problems. And it works just like new!

Help other customers find the most helpful instructions.

Were these instructions helpful?

< PREVIOUS 1 2 3 4 5 6 NEXT > 16-30 of 77