| |
1 of 1 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
Customereugene from kissimmee FL
Hinge pin broke off
take out two nut driver screws remove piece, take off track two philips head screws. transfer temp control rod, really easy then put track back on and install piece. probable took as long to remove the two veg crispers and glass top. this is a very easy fix. i did notice that the pin on the original was about 3/8 of an inch forward so flapper door did not quite line up and im sure caused the pin to snap off. the replacement part, the pin is exactly the same position as the other side. i believe the original was defective from the mfgr.
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsNutdriver
Customerjoel from reynoldsburg OH
Broken end cap on pantry shelf
remove the three screws which holds the end cap in place. transfer the track to the new part and the temperature control. replace the three screws. very easy!
|
1 of 1 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers, Socket set
CustomerPamela from So. Berwick ME
Peg boke off of panty door holder
Ok..way easy and as my kids would say "easy breezy lemon squeezy"! Even a chick can do it with the right tools! Shipping was fast, replacement part inexpensive and life now much less frustrating when all the fridge parts works!! Took out three screws, took off right drawer slide, lifted the glass on top used socket for remaining two screws and voila, reversed the steps and all was done.
|
1 of 1 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsSocket set
CustomerRobert from West Chicago IL
The tab that is used to swing the cover on the lower tray broke off on one side.
First, I took out the glass tray along with the two slide out compartments that are part of that assembly. Then I used a small socket set to take out the three screws that hold the part in place and along with the part a plastic connector comes out with it that adjusts the temp of the bin area. Line up the holes on the slider and two screws come out that hold the slider to the part. Disconnet the plastic piece in the back that adjusts are flow (press down plastic holders) Reattach the slider, snap the plastic piece on the back and reassemble. Sounds complicated but once you are in there, its self explanatory.
|
1 of 1 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsNutdriver
CustomerLinda from West Harwich MA
Clips to pantry drawer lid had been broken off
First I removed the pantry drawer; then the two crisper drawers and glass shelf. Then I removed the hex screws that held end cap in place. Removal of cap from refrigerator was complicated by the adjustable temperature control - it is loosely attached at the back of end cap and also has to be removed to get cap out. Gentle persuasion accomplishes this. Getting the slider off end cap also a bit difficult. Then I removed the drawer glides. Reversing all steps was fairly easy and the rest of the "fix" went well. I wished that there had been some written directions - or at the very least, a diagram of how all went together. All in all was still cheaper than repair person.
|
1 of 1 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsNutdriver, Screw drivers
Customermichael from wenham MA
Pin on end cap broken
the only thing easier than installing the part was finding it on this website.
10 minutes max start to finish.
Removed the 2 fruit & veggie drawers & deli drawer and glass top. Nut driver to remove the side end cap. Remove and replace the rails onto the replacement part and reattach. Simple.
It had been broken for months and I just kept putting off calling a serviceman. Boy am I glad I found your site. I don't even want to think about what this may have cost. When the kids break something else I'll be ready !!
|
1 of 1 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsScrew drivers, Socket set, Wrench(Adjustable)
Customerjames from atlanta GA
The hinge for the drawer cover broke
First my wife removed the food and the drawer from the unit. She then removed the screws and nuts securing the unit. The end cap was then removed and the new end cap placed. The temperature linkage and knob were reconnected and all screws and nuts tightened. Last the drawer was slid bback in and the drawer cover was hooked back to the brackets.
|
1 of 1 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerSal from Guilford CT
Pivot for pantry door on right hand end cap was broken
Removed the Pantry drawer, glass top and plastic supports.
Removed the Right Hand end cap by removing the three holding screws with a nut driver.
Removed the slid out metal rail from the end cap along with the slide mechanism for temperature control.
Replaced all of the parts in reverse order.
|
2 of 4 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerBarbara from East Islip NY
Broken side piece on slide out drawer
It was very easy to replace the broken piece. My husband did it in about 15 minutes .
|
1 of 2 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver
CustomerClaude R. from Clarkesville GA
The lid tab on the wide-n-fresh lid was broken off
I ordered the part and it arrived in about 5 days. I removed the two lower crisper drawers and the glass shelf seperating these from the Wide-N-Fresh compartment, to give me room to work. I removed the two screws holding the right side endcap in place. The temperature adjustment mechanism was a bit tricky to remove from the broken endcap and replacing it on the new endcap. Once that was figured out everything fell into place and the lid was snapped into place and worked properly
|
1 of 2 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerJames from Voorhees NJ
End cap on the rh pantry drawer snapped off
Remove the crisper drawers and the glass shelf to give yourself plently of room to maneuver.
The repair was simple, but the part did not include new screws which would have been helpful since one of the screws was stripped. The pantry lid still doesn't fit as well as we'd like which may be a result of one of the screws not holding tight.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerMerrill from Colorado Springs CO
Pantry lid broken, center rail broken, pan corner cracked
Remove broken parts with philips screw driver (6 screws). Replace encaps while attaching pantry drawer lid. Insert center rail and new drawer.
|
1 of 2 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsSocket set
CustomerScott from Penfield PA
Pin brokeoff that held pantry door.
Took out veggie drawers and glass support. Removed 3 screws, took pantry cooling controls of old part put on to new replaced screws and reassembled glass support and veggie drawers. Very easy.
|
1 of 2 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsSocket set
CustomerColin from Litchfield Park AZ
Broke the pivot stud for the pantry drawer door
Removed the vegetable drawers, then the glass shelf over the pantry drawer, removed the pantry drawer to expose the right hand end cap. Removed the end cap and removed the moisture control mechanism, re-attached the moisture control mechanism to the new end cap, replaced the end cap, shelf and drawers. The hardest part was figuring out how to remove the moisture control mechanism from the old end cap. You have to slide it to the back of the end cap to pop it loose from the end cap, rotate the mechanism to allow the actuator to be removed from the moisture control thumb slide.
|
1 of 2 people found this instruction helpful
Parts Used
-
- Pantry End Cap - Right Side
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsNutdriver
CustomerJim from Salem MA
Broken arm that is used to open the pantry door like a hinge
removed the two veggie draws, then the glass top, then the pantry draw...remove three screws. remove the temp adjustment lever and install on new end cap. install end cap and draws etc...took about 15 min.
|