Temperature Sensor Kit

PartSelect Number PS236490

This kit includes the sensor as well as the connectors. NOTE This sensor is 2" long.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Little to no heat when baking.
  • Oven is too hot.
  • Compare At

    $121.93
  • You Save

    $20.32
  • Your Price

    $101.61
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.9 / 5.0, 4 reviews What's this?
1-4 of 4
 

25 of 47 people found this instruction helpful

Parts Used

  • Temperature Sensor Kit

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver

CustomerCHARLA from NEW BRAUNFELS TX

Oven sensor was not holding temperature range.

Per the instructions included with part.

Help other customers find the most helpful instructions.

Were these instructions helpful?

13 of 16 people found this instruction helpful

Parts Used

  • Temperature Sensor Kit

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsScrew drivers

CustomerArmand from COVENTRY CT

Defective temp. Sensor

Removed oven from cabinet. unblug old sensor pluged in new and reinstalled oven. Esay repair though wish oven was designed so did not have to pull itout of cabinet which requires disconect electric cabel

Help other customers find the most helpful instructions.

Were these instructions helpful?

9 of 9 people found this instruction helpful

Parts Used

  • Temperature Sensor Kit

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsNutdriver, Screw drivers

CustomerJack from Cypress TX

When baking at temps > 400 the oven would beep with an error code f5 and shut off

I downloaded the installaion manual from the web for this model. First htings first, I located the circuit breaker for the oven and turned it off. Removed the lower trim piece from the bottom, next lifted the oven door off its hinges and set it to the side. I then wrapped a couple of small towels around the hinges for the door as per the manual (the hinges can pinch a finger). I then removed the four screws which secured the oven into the cabinet. Next I slid the oven forward allowing me access to the rear. I removed the pieces from the rear to gain access to the sensors connector, and unpl;ugged the sensor. Went around to the front and unscrewed the 2 screws securing the sensor and removed it. I then installed the new sensor, replaced the rear covers, slid the oven back into the cabinet, secured the four screws, snapped on the lower trim, remounted the oven door, and turned the breaker on. Oven working fine now.

Help other customers find the most helpful instructions.

Were these instructions helpful?

10 of 14 people found this instruction helpful

Parts Used

  • Temperature Sensor Kit

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver

CustomerRaymond from Madrid IA

Oven was not reaching or maintaining temperature.

Took off oven door and removed racks. Removed the cover on the back side (5 screws removed with nut driver) Pulled sensor out the front side of the oven. Threaded the new sensor through and put all back together.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-4 of 4