2357915-2-S-Whirlpool-5765M433-60-Control Panel with Touchpad
2357915-2-S-Whirlpool-5765M433-60-Control Panel with Touchpad 2357915-1-S-Whirlpool-5765M433-60-Control Panel with Touchpad

Control Panel with Touchpad

PartSelect Number PS2357915

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Will not program.
  • Compare At

    $190.28
  • You Save

    $31.71
  • Your Price

    $158.57
In Stock
Order within the next 9 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.6 / 5.0, 2 reviews What's this?
1-2 of 2
 

3 of 3 people found this instruction helpful

Parts Used

  • Control Panel with Touchpad

Level of DifficultyA Bit Difficult

Time to do repair:15 - 30 mins

ToolsScrew drivers, Wrench set

CustomerJulio from Chula Vista CA

Some of the control panel buttons did not respond

Disconect the oven, (electrically and the gas of the stovethat is on top) I removed the to cover of the oven. Remove the connectors of the eletronic circuit. Remove the whole panel by removing the 4 screws 2 each side.

Remove the electronic circuit (including the clock) and install it on the new panel. connect the flat circuit cables that connect the front panel to the electronic circuit.

Assemble the panel to the oven. connect the harnesses. close the cover and screw it. reconect the stove (gass and electric).

Done!

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 5 people found this instruction helpful

Parts Used

  • Control Panel with Touchpad

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Wrench set

CustomerDavid from San Diego CA

Control panel buttons not working

Make sure oven is unplugged or breaker switch is OFF.

Pull the oven roughly 1/3 of the way out.

There are two bolt screws on each side of the control panel that become visible upon pulling the oven out. Remove these bolts with a nut driver.

Carefully pull the panel 180 degrees downward and being careful with the attached wiring.
Unplug the two strip cables going into the control box by lifting up on the plastic holders.

Find the outer-most bolts, 2 on each side of the control panel innards, and remove them and then remove the entire control panel.

Remove the silver heat shielding from the old control panel and put it in the same way on the new one. Re-connect the two strip panel cables the same way it was connected, make sure everything else is still plugged in!

Re-bolt the the panel to the control box with the 4 outer screws.

Line up control panel and re-bolt the 4 outer-screws on the side of the oven

Gently push the oven back in place.

Cook brownies to celebrate!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2