Quick Question!

Have you ever purchased from PartSelect.com before?

2357914-1-S-Whirlpool-5765M432-60-Control Panel with Touchpad
2357914-1-S-Whirlpool-5765M432-60-Control Panel with Touchpad 2357914-2-S-Whirlpool-5765M432-60-Control Panel with Touchpad http://www.partselect.com/Schematics/Maytag/55443.gif

Control Panel with Touchpad

PartSelect Number PS2357914

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Will not program.
  • Touchpad does not respond.
  • Will Not Start.

Compare At

$206.29

You Save

$34.38

Your Price

$171.91
Order within the next 5 hrs and your part ships today!
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 2 reviews What's this?
1-2 of 2
 

24 of 33 people found this instruction helpful

Parts Used:
  • Control Panel with Touchpad
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver, Screw drivers
Customer: alfred from forest hill, TX

Keys would not work

Removed power to oven, pulled the oven out, removed the four mounting bolts. removed control plastic ribbon cables. installed new control unit, installed ribbon cables restored power to oven then tested keypad, set clock, and reconnected oven to wall pandling.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

6 of 8 people found this instruction helpful

Parts Used:
  • Control Panel with Touchpad
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Wrench set
Customer: David from San Diego, CA

Control panel buttons not working

Make sure oven is unplugged or breaker switch is OFF.

Pull the oven roughly 1/3 of the way out.

There are two bolt screws on each side of the control panel that become visible upon pulling the oven out. Remove these bolts with a nut driver.

Carefully pull the panel 180 degrees downward and being careful with the attached wiring.
Unplug the two strip cables going into the control box by lifting up on the plastic holders.

Find the outer-most bolts, 2 on each side of the control panel innards, and remove them and then remove the entire control panel.

Remove the silver heat shielding from the old control panel and put it in the same way on the new one. Re-connect the two strip panel cables the same way it was connected, make sure everything else is still plugged in!

Re-bolt the the panel to the control box with the 4 outer screws.

Line up control panel and re-bolt the 4 outer-screws on the side of the oven

Gently push the oven back in place.

Cook brownies to celebrate!!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2