2357561-1-S-Whirlpool-5701M382-60-Electronic Control - Gray/Black
2357561-1-S-Whirlpool-5701M382-60-Electronic Control - Gray/Black 2357561-2-S-Whirlpool-5701M382-60-Electronic Control - Gray/Black 2357561-3-S-Whirlpool-5701M382-60-Electronic Control - Gray/Black

Electronic Control - Gray/Black

PartSelect Number PS2357561

Used with black appliances.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $377.18
  • You Save

    $62.86
  • Your Price

    $314.32
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.0 / 5.0, 3 reviews What's this?
1-3 of 3
 

2 of 2 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerRandy from Effingham IL

Control panel replacement.

Removed back panel on stove. Removed old control panel (4 screws. Unpluged wireing making sure to note color location and reinstalled control panel.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

  • Electronic Control - Gray/Black

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerJeff from Milford OH

Control board problems

It took longer to move the gas range from the wall and unplug the electric feed than it did to do the repair.

There are 3 screws on each side of the range top cover to remove. The cover is lifted up and rolled forward to expose the controler. Remove the 4 screws that hold the controler in place and install the new controller. Remove the 5 plug in wire connections (one at a time) and reinstall on the new controller.

You are done. Reassemble in reverse order.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 2 people found this instruction helpful

Parts Used

  • Electronic Control - Gray/Black

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsScrew drivers

CustomerMarco from Parsippany NJ

Oven wouldn't heat, clock doesn't work.

Steps to fix it:
Warning! Turn the power off before starting to work on this range. Personal or equipment damage may occur if power is on.
Part to be replaced: clock w/overlay unit(part # 74006194).

1. Remove two screws located at top right and left of end caps; remove two screws located at bottom right and left of end caps in the control panel.
2. Remove two screws from top rear of control panel.
3. Loosen the control panel from the housing to gain access to the clock w/overlay unit.
4. Remove all electrical connections from old clock w/overlay unit.
Caution!
It's critical to note the position of each electrical connector in order to avoid a miswiring when replacing the new part.
5. Loose four screws to remove the old clock w/overlay unit from the control panel.
6. Put the new clock w/overlay unit and tighten it up with four screws.
7. Hook up all electrical connections that were removed in step 4.
8. Put back this unit to the housing of control panel and install all screws that were removed in steps 1 and 2.
Reconnect electric power.
End of steps.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3