2353893-1-S-GE-WD26X10039-Drain Pump
2353893-1-S-GE-WD26X10039-Drain Pump 2353893-2-S-GE-WD26X10039-Drain Pump

Drain Pump

PartSelect Number PS2353893

The pump ejects the water from the dishwasher.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Not draining.
  • Noisy.
  • Compare At

    $60.73
  • You Save

    $10.12
  • Your Price

    $50.61
In Stock
Order within the next 7 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.2 / 5.0, 2 reviews What's this?
1-2 of 2
 

18 of 20 people found this instruction helpful

Parts Used

  • Drain Pump

Level of DifficultyEasy

Time to do repair:1- 2 hours

ToolsNutdriver, Screw drivers, Wrench(Adjustable)

CustomerEric from Leander TX

Water was not draining out of the bottom of the basin

The dishwasher was disconnected and pulled out. I turned it over onto it's side so I could get down to the drain pump. It looked exactly like the original part and fit just as well. The hoses came right off and then once it was replaced, slipped right back on. It all worked like a charm. The only problem I had was after the repair. The copper water line moved around too much and caused a leak at the connection at the dishwasher. Luckily I tested the line outside before I reinstalled it completely. I just went and bought an $11 flexible hose with new fittings on either end and replaced the copper lines. It went on easier and it sealed tight.

This was a pretty easy repair and I am glad I did it. We were on the verge of just buying a new one, but for a $35 part and a couple hours, it was well worth it.

Help other customers find the most helpful instructions.

Were these instructions helpful?

8 of 13 people found this instruction helpful

Parts Used

  • Drain Pump

Level of DifficultyReally easy

Time to do repair:30 - 60 mins

ToolsNutdriver, Screw drivers

CustomerCHARLES from BURTONSVILLE MD

The mount for the pump was damaged in shipping. We remodeled our kitchen so we ordered the appliances befor we were ready to install them. They looked ok when got them but when we opened them the dishwasher was damaged. I tried to fix the problem but I couldn't get the vibration out.

First thing I did was to turn off the water and electrial supply. Then take the side mount screws and remove the base cover disconect the water line slide out the washer. I then put a pad on the floor turn the washer face down on the pad. I disconected the drain line lossened the clamp on the pump. Then disconected the two wires and removed the pump.I then installed the new pump tightened the clamps reconected the two wires then conected the drain line. I then slide the washer back in place reconected the water line put the side mount screws in place. I then turned the water and electrial supplies back on. I then ran the washer to check for leaks. No leaks found iI then reinstalled the base plate. The vibration was gone after replaceing the pump. Thanks Charlie

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2