Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS2353273
This filter works only with plastic lines. It has a new design with quick connect fittings at the end of the filter.
This part works with the following brands: GE, Hotpoint & Kenmore.
Replacement auger and ice bucket assembly was perfect. Just had to remove the front door/flap assembly from the old unit and screw on to the new. The water filter kit took more time to read the box instructions than it did to install. Perfect. Am very pleased with the service/value offered by PartSelect.
Help other customers find the most helpful instructions.
Were these instructions helpful?
the back plate was removed and the solenoid part was removed for ordering. when installing, the same plate was removed. then the part was installed. also we put in an in-line water filter. that just included splicing the common inlet tube prior to the soloniod entrance and installing the filter.
After I realized that I needed to take the front and door off the old ice bucket (which involved removing 4 screws) and mount it on the new part (putting in those 4 screws), the job was easy. Installing the new assembly requires shoving it into place without really being able to see how or where it attaches, so I wasn't sure it worked until it produced ice a few hours later, and it did.The filter on the fridge was more than 10 years old, but the new GE Smart filter and its adapters screwed and snapped into place easily. Subsequent filter changes will be simple - just a snap!
It originally appeared that an easy out would be required to remove ferule from piping line, but later it became necessary to cut old broken fitting off and replace with compression fitting in replacement kit. Total time to repair after all tools were on hand (needed to buy tubing cuter) was about 45 minutes.
Removed the old ice bucket from the freezer and placed the ice in a plastic bag to reuse. Removed the ice bucket front cover by removing six (6) screws. Installed the old front cover to the new ice bucket by using four (4) screws. Replaced the new ice bucket in the freezer and filled it with the ice. Also replaced the water filter. The ice bucket repair was very easy and fast. Filter replacement took more time since I had to go buy some new tubing.
i replace the IM3 with a upgrade to the IM6 ice maker. a simple swap and easy to install. with very good instructions.
The light shield was easy, except there were no instructions. so It took a minute to realize that you have to remove the ice maker to unscrew the portion that slides up to fit in its place. then it was quite simple.The water filter however was a bit more challenging. We had to take off both ends of the filter to be able to attach to the water line we have set up in the basement. My brother is handy, so after a little while he figured out how to install the filter. now it is on fine and the water taste better.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.