2352995-2-S-Frigidaire-154712101-Control Board With Selector
2352995-2-S-Frigidaire-154712101-Control Board With Selector 2352995-1-S-Frigidaire-154712101-Control Board With Selector

Control Board With Selector

PartSelect Number PS2352995

This is a 4-button board. This part would be the main "brains" of the appliance which is activated by selecting a certain function with the touchpad.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Will Not Start.
  • Compare At

    $151.20
  • You Save

    $25.20
  • Your Price

    $126.00
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 3 reviews What's this?
1-3 of 3
 

13 of 15 people found this instruction helpful

Parts Used

  • Control Board With Selector

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerJonathan from Stamford CT

Drain motor would not run

I remove the 5 or 6 screws that hold the plastic decorative top front cover in place (the screws are on the inside of the door). Lifted and pulled the cover off of the door. Pushing in the two side clips, detached the control module power/control connector from the door. Removed two screws that hold the control module to the cover, then released the snapping clips that hold the control model in place. Reversed all the steps and ran a test cycle. It worked! Thanks PS!

Help other customers find the most helpful instructions.

Were these instructions helpful?

8 of 9 people found this instruction helpful

Parts Used

  • Control Board With Selector

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerMary Lou from Evans CO

Dishwasher wouldn't start, then became stuck in a cycle.

Pull the control knob straight out. Remove the screws along the top of the door, and the top two along the side near the top. The whole control panel will then fall away.

Unplug the old plug by squeezing the tabs and pulling.

Remove the two short screws that hold the control board to the plastic panel. After that, the board is still tightly held in place by a series of snaps around the perimeter. Most come free with a little work with a flathead screwdriver. The tough ones are underneath -- flip the whole plastic panel over to find an access for those.

Snap the new controller in place, install the two screws. Plug the wires back in (it is keyed and will only plug in the correct way). Put all the screws back in and you're ready to test.

The very first test I ran did not go well -- the dishwasher thought it was full of water when it wasn't. You may need to cancel the first cycle and start a fresh new cycle.

Help other customers find the most helpful instructions.

Were these instructions helpful?

7 of 13 people found this instruction helpful

Parts Used

  • Control Board With Selector

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerTed from Montague NJ

Washer would not start cycle proper.

Removed 5 screws unplugged wire harness removed control module and replaced.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3