32 of 39 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerRobert from Olathe KS
Dishwasher would not do anything
1. Turned off power at breaker. 2. Removed the six screws holding the interior panel to front panel. 3. Disconnected the power cables from the soap door and the handle release. 4. Removed the 3 screws holding the computer control board. 5. Removed the wire bundles from the board...only one way to take them off and put them back on...very easy. 6. Found two clips holding the board in place and removed the computer control board. 7. Replaced with new board into clips...and re attached the wire bundles. 8. replacing the panel control was a snap with 2 screws and the wires fit onto the control board easily. 9. Replaced the interior panel and attached the wires back to the handle release and the soap dispensor. 10. Replaced the screws for the panel. 11. Reset breaker 12. Wahlah....ran the dishwasher like it was new.