Quick Question!

Have you ever purchased from PartSelect.com before?

2342883-1-S-Frigidaire-318293827-Surface Burner Switch
2342883-1-S-Frigidaire-318293827-Surface Burner Switch 2342883-2-S-Frigidaire-318293827-Surface Burner Switch 2342883-3-S-Frigidaire-318293827-Surface Burner Switch http://www.partselect.com/Schematics/Frigidaire/F6571S82.gif

Surface Burner Switch

PartSelect Number PS2342883

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Element will not heat.

Compare At

$43.33

You Save

$7.22

Your Price

$36.11
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 2 reviews What's this?
1-2 of 2
 

16 of 20 people found this instruction helpful

Parts Used:
  • Surface Burner Switch
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Gary from Herrick, IL

Burner would consistantly go to high no matter where the dial was positioned.

First I unplugged the stove.Removed the upper control panel back (10 phillips screws). Removed the plastic dial( pulls straight off). Removed the 2 screws behind the dial that is holding the switch in the control panel. Took one wire at a time off the old switch and put them on the new switch according to each electrical spade marking. L1, L2, H1, H2 and P. Installed the new switch in the control panel securing it with the 2 screws. Installed the dial, installed the upper back panel using the old screws. Plugged the stove back in and tested it.
Note: My new switches shaft was 1/8 of an inch longer so it does put the dial a little further away from the control panel. Wife says: It's OK, don't worry about it.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

5 of 7 people found this instruction helpful

Parts Used:
  • Surface Burner Switch
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Marilyn from Lafayette, GA

One of the switches on my stove had quit exept for high. Every level on the switch was high.

First I removed the 2 screws that held it in place.
Then I took te screws out of the backguard cover and pulled it down so that I would get to it. Then I unplugged the wires, and replugged them on the new switch, then screwed it back in to the range, then put all the screws back in backguard cover, and plugged the range back up and put it back in its place. It was real easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2