Exterior Door Glass

I took out the two screws that held the oven handle in place inserted the glass in the door and replaced the two screw!!! That easy!

I'm still unsure why it broke ,but it was just a matter of removing two screws that hold the handle in place and sliding in the glass...

We removed the door from oven assembly and laying it flat on the bench removed the stainless steel cover from the rest of the door. Removing the shattered pieces of safety glass was done heating and scraping off vinyl tape.(difficult.)Caution! Do not allow any pieces of glass get under the stainless steel cover, it will leave ugly scratches! We purchased double sided vinyl tape 1/2" wide, 1/16" thick and aluminum "Flue tape" (600 deg. F) 1 1/2" wide from local hardware store to replace the original ones in their previous location. Fitting the new glass on sticky tape has to be done accurately. (no problem). Assembling it was little tricky but still within the ability of a do-it-selfers. We wondered if we should not put the rough side of the glass facing in or out. The original was with the smooth side out so that what we did. If any additional scraping of accumulated grease is needed especially on the inside glass, it requires more disassembly, but we would strongly suggest doing it (we did), while it is all opened. To our surprise the glass arrived by Fed Ex within 24 hours of ordering and now our Whirlpool is gleaming like new again. The cost of this product with shipping/handling by PartsSelect was much lower than ordering it from the other "original" source. Thank you! Sincerely Fred T.

I had ordered the parts from Part Select and came with in a week. I ahd a Whrilpool microwave that had a door panel and vent grille that needed to be replaced and that was rplced with ease took less that five minutes to do. My Maytag refridgerator had it kickplate grille replace along with the pivot block that took all of about two minutes. The longest job that took about 5 minutes was my Whirlpool glass oven door that needed to be replaced, but that was pretty ease to replace also with an extra hand from my son. I just didn't want to break another glass door or I would have done it myself plus I was teaching him how to do self reparts.