http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/54089.gif
See part 1 in the diagram
http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/54089.gif

Control Panel with Touchpad - Black

PartSelect Number PS2341087

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Will Not Start.
  • Compare At

    $215.86
  • You Save

    $35.98
  • Your Price

    $179.88
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.2 / 5.0, 3 reviews What's this?
1-3 of 3
 

12 of 16 people found this instruction helpful

Parts Used

  • Control Panel with Touchpad - Black

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver

CustomerJody from Spring Hill, FL

Start button and some option buttons did not work.

Unscrewed Torque Head Screws from inside Door Panel. I left the 2 cables that were attached to the Door Panel on, and just set the Door panel off to the side. Disconnected Ribbon Cable from Control Panel to Main Control Board, by sliding White Locking Tab on the Main Control Board Connector down to release the Ribbon Cable. Then unscrewed the rest of the screws that held the Control Panel.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 4 people found this instruction helpful

Parts Used

  • Control Panel with Touchpad - Black

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver

CustomerMark from Essex Jct, VT

Led flashing and start button no longer works. Found the flex cable to the touch panel was burned out. I would see the black burn spots on the flex cable.

First I turned off the power at the fuse box. I then removed the 10 screws that hold the door tub panel in place. Then separated the door tub panel from the door. Removed the 3 screws for the black control box. I unplugged the flex cable that runs to the touch panel from the black control box. This is done by sliding the white rectangle clip that holds the flex cable. I then removed the 4 screws that hold the front touch panel, which I was replacing. Put on the new touch panel. Replaced the 4 screws. Plugged the flex cable back into the control box. Slid the white rectangle clip back in place to hold the flex cable. Replaced the screws on the control box. Put the door tub panel back in place and replaced the screws. Power turned on, all done and it worked.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

  • Control Panel with Touchpad - Black

Level of DifficultyReally Easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerSandra from Bluffton, IN

Dish would not work at all

. First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires...)

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3