Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS232502
This part works with the following brands: GE, Hotpoint & Kenmore.
Other writers have claimed that this is a "really easy" job. They apparently had one or more of: 1. Less used appliance. 2. Never spilled anything on the cooktop 3. Much better luck. In my case, the apparently faulty igniter absolutely would not pull out. I removed it by removing the burner retaining screws and prying under the burner casting. Having done that, I cleaned the igniter and tested it again. None of the igniters worked, and I could hear arcing under the cooktop, indicating one or more of the igniter HV wires had somehow grounded. After a fruitless search for instructions on raising the cooktop, I stumbled upon an envelope glued to the back of the range that told me to remove all four burners and igniters and to release the cooktop by inserting a thin screwdriver under the front edge about 3" from each end to release the spring clips. Several of the igniters were cemented in place with caramelized sugar and required some pretty vigorous prying to dislodge. If I had this to do again on a range that had been ridden hard, I wouldproactively order a full set of gaskets (they're fragile), the HV harness (even if it doesn't leak as mine did, the igniter connectors degrade from heat exposure), a set of electrode mounting clips (none of them were much use either), and enough igniters to replace any that don't work plus at least one. I pried out the recalcitrant igniters; in retrospect I should have crushed them because of the severe risk imposed by prying of breaking either a burner casting or the cooktop -- either of which are far more expensive than another igniter.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Repair to range went real well, Lifted range from counter. Removed eight screws that secure burnerassembly. Lifted burners from it's position, andremoved igniters. Installed heat srink at burner connections so as to ensure high voltage wouldhave no leaks. Removed insulation, and installedspark module.. Reassembled unit, placed in counter cut out, put 110 volt cord into outlet.Tested all burners, everything worked great..The repair took about hour and 15 minutes.Have fun and be careful...... THE END
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.