| |
5 of 6 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
ToolsNutdriver, Screw drivers
CustomerRoger from Peoria AZ
Stripped out helix lock, broken bucket glide rails
PITA to take apart, finally had to use two screwdrivers to pry up on the mechanism that turns the auger in order to gain access. Once I figured that out, the rest of the repair was a breeze.
|
4 of 4 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers, Socket set
Customerjohn from Peoria AZ
Glide bucket lh was broken
When I arrived from work, the job was already done and it was installed by my 18 year old son in 15 minutes without my supervision.
|
3 of 5 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers, Socket set
CustomerRyan from Deltona FL
Glide broken and wouldn't hold ice bucket motor in place.
Removed the 3 screws using a socket set. Removed 1 screw with the broken plastic piece off of the ice bucket motor by holding the broken plastic with pliers and removed screw. Be aware that the glide rail screws are standard socket size while the ice bucket motor screw was slightly larger (don't remember the exact measurements). Attached new Bucket Glide. Fixed.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerNeal from Haverhill MA
The left hand glide broke and could not support the ice bucket
I think there were 3 philip screws to remove, take off the existing glide and replace with the new part. A very simple repair and saved about 175.00 if called in a professional, Thanks Part Select
|
1 of 3 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsSocket set
CustomerDonald from Henderson NV
Torque from ice auger broke bucket glide bracket
Removed four screws from broken glide bracket and auger bracket and remove. Replaced with new glide bracket and reinserted ice bucket to connect auger with auger motor. Two socket size job.
|