Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS2322190
This part works with the following brands: GE, Hotpoint & Kenmore.
Don't order new gaskets--they come installed on the new maintop. 1. Pull oven out from the wall, 2 Remove two screws, one on each side toward the rear.3. Remove the controll faceplate by removing the four rotary switches and unscrewing the retaining rings underneath the rotary switches. When lifting the faceplate, be careful to disconnect the wiring harness attached at the bottom of the right third of the facepalte to avoid bending the tines.4. Removing the faceplate gives you access to six screws (nutdriver) attacing the mainoven to the glass top unit. Remove them all.5. Slightly lift the glass top and tilt from the rear toward the front to get access to the underside. 6. There are 4 burners and the "surface hot" light unit attached to the bottom of the glass top. Disconnect the surface hot light by easing it out and let it hang, Remove the burners (recommend right to left) by unscrewing (nutdriver) the screws which hold the nine burner retaining clips . Lay the burners on the oven. 7. Remove/discard the old glass top.8. Use a towel folded over to provide a cushion under the front edge of the new glass top as you install the new burners.9. Install everything in reverse order.
Help other customers find the most helpful instructions.
Were these instructions helpful?
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.