Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS231473
This hinge kit is used on the right hand side of the oven door.
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
This hinge kit is used on the left hand side of the oven door.
I took the door off, removed the four phillips screws that held the wall oven in it's hole. All the 1/4" fasteners were on the face of the over but you have to pull the oven forward to remove the hinges.Buying thes two hinges from G.E. would have cost $ 90.00 I paid $ 55.00 from Part Select and they arrived the NEXT DAY. I did not do rush shipping.
Help other customers find the most helpful instructions.
Were these instructions helpful?
One hinge assembly wouldn't close all the way, so the door wouldn't close completely. Removed the door. Removed the screws holding the entire oven to the cabinet (6-8 screws) and pulled out the whole oven about 6 inches. Since it's big and heavy, I rested it on an old plastic milk crate. The pulley inside one hinge assembly was broken. It's held in by two screws from the front, removed those, took out the old assembly, put in the new, put the screws back in, pushed the whole oven back into the cabinet, put the screws back in to hold it to the cabinet, and put the door back on.
Removed the oven door. Removed screws on side strips and on oven frame where springs were located. Pulled out oven so I could reach the springs. Removed old springs and installed new springs. Installed side strips and remaining screws. Pushed oven back in place and put the door back on.
Could not find any instructions in the owners manual. Spent 30 minutes removing screws around the oven trying to get to the hinge and fortunately I finally removed the facing where the controls are. I found a technicians guide behind it which had diagrams and instructions for removing the 4 screws attaching the oven to the cabinetry. This released the entire oven assembly so it would slide out 6 inches for access to the hinge. Everything went easily then!
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.