| |
4 of 5 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerGreg from Towanda PA
Clips holding folding tines broken
The clips holding the folding tines on the lower rack had broken, so the folding racks were flopping around. I entered the model number an PartSelect popped up exactly the right diagrams to find the parts I needed - I even found the handle for the silverware tray that I didn't know was missing. I ordered before noon, and the parts arrived the next day, all at a very reasonable cost (even shipping!) the parts just snapped in place. I'm very, very pleased.
|
3 of 4 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerLiz from Alexandria VA
Dishwasher lower basket suffered from wear and tear
Slipped into place the two wheels on lower basket that had gone missing; removed brackets for adjustable section that were broken and easily snapped knew ones into place; connected handle to flatware basket and replaced the old one. Why we didn't do this years ago!
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerEUGENE from MADISON IN
Silverware basket was broken on the bottom
The only problem was the handle arrived about week before the basket because of an inventory problem. The fix was to insert the handle into the basket and we were ready to go. No tools and no mess taking a minute or two to accomplish and it is as good a new. Thanks!
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerReavis from Royal Oak MI
Maytag baskets fall apart and need to be replaced
Removed old unit, snapped handle onto new unit and installed it
NOTE: THE DIMENSIONS SHOWN ON THE ORDERING GRID ARE NOT ACCURATE. THE UNIT IS MORE LIKE 9 INCHES LONG INSTEAD OF 11 AND 6 INCHES WIDE AS OPPOSED TO 7.
This error occured on several websites so I suspect that Maytag's specs are off.
|
2 of 7 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerSteve from Pasco WA
Dishwasher rack wearing out
This repair was very easy to do. Removed the old rack and removed the center spray diverter and reinstalled in the new rack. I also replaced the front panel as the old one was dented. This was very easy as well removed two srews and the panel slide off and the new one installed just as easy.
|