7 of 10 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:1- 2 hours
CustomerMichael from Silverdale WA
Plastic bezel broken
1 - Unlugged power cord.
2 - Reviewed main plastic panel to see where required screws were located.
3 - Removed 8 screws on inside stainless panel.
4 - Separated the loose panel while removing screws holding the front plastic bezel in place. Removed two screws hold latch in place.
5 - Noticed that two screws were holding the PC board down plus a retaining nub on the plastic piece. Removed screws and held PC board out of way.
6 - Pulled off plastic splash shield held down with sticky gunk.
7 - Was a little difficult keeping the front door panel separated from the inside panel while doing all the work.
8 - Installed new handle into latch device and then attached to inside of door.
9 - Put it all back together twice after forgetting to install the two PC board screws. Oops.
10 - Felt confident the repair was correct when done.
Parts arrived as promised. Web exploding details insured exact replacement part.
4 of 7 people found this instruction helpful
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerKenneth from Cedar Park TX
Door handle latch broken / front panel broken
Maytag repair man 1 year ago caused most of the damage after I took the front cover off - the repairman broke off most of the screws holding the front panel in place leaving me to replace the front assembly.
The repair was easy - save yourself and do it yourself vs paying someone alot of money to only make it worse in the long run...