2200595-1-S-Whirlpool-Y314137-Single Rubber Foot
2200595-1-S-Whirlpool-Y314137-Single Rubber Foot 2200595-2-S-Whirlpool-Y314137-Single Rubber Foot 2200595-3-S-Whirlpool-Y314137-Single Rubber Foot

Single Rubber Foot

PartSelect Number PS2200595

This gray levelling leg foot pad is made of rubber.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $4.63
  • You Save

    $.77
  • Your Price

    $3.86
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Videos For installing this part.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Leveling Leg

Part Number 2180254

$4.60
In Stock

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.1 / 5.0, 3 reviews What's this?
1-3 of 3
 

1 of 2 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerGERALD from ALBUQUERQUE NM

Broken belt

Followed the instructions supplied with parts. My wife was so happy and the repairs were easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsPliers

CustomerDennis from Granada Hills CA

Warn out foot pads

Pried off old pads - used hammer to tap on new pads.

Locating replacement parts was the problem until I found partselect.com

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:30 - 60 mins

ToolsNutdriver, Screw drivers

CustomerCoyote Custom Builders from Phelan CA

Belt was hard and made a squeaking nosie, rubber pads were o good because of age.

First I disconnect the electrical power, 2nd disconnect the vent tube, 3rd removed the four screws on the back of the dryer, 4th removed the front panel and disconnect the wires for the door switch, 5th remove the cover that holds the drum inplace, 6th remove the belt, 7th vacum all parts to remove any lint and dirt from the inside of dryer, 8th reassemble the parts in the reverse order. this took me about 55 minutes from start to finish. The parts were right which made the job very easy. The rubber foot pads were easy, just remove the old ones and install the new ones. Thank you for the right parts.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3