13 of 17 people found this instruction helpful
Level of DifficultyEasy
Time to do repair:15 - 30 mins
CustomerWilliam from Houston TX
Replaced ignitor - natural gas oven
Oven was lighting slowly and finally just stopped lighting. I ordered and replaced old ignitor with a new one. The actual repair is pretty easy. However, this is the second one I purchased, the first one was broken by me while inserting it into bracket. The active part of the ignitor (the part that heats up) is extremely fragile, more fragile than fluorescent bulb glass. Do not allow it to touch anything while inserting it. Do not drop, even a few inches. The ceramic housing meanwhile is indestructible. The wires won't have connectors on the ends so, you need to get some heat resistant wire nuts and heat resistant tape to safely splice the wires back onto the old wire mount points. Or, If you wish, you can make new connectors and wrap in asbestos sheaths and re-attach to the oven. There does not seem to be a pattern to replacing the wires in the right order. Just as long as they both are securely connected. The bracket is held by 3 screws, easy to remove and replace. You'll need to remove the old ignitor and replace the new one the same way. The elements are not screwed in, they just slide in. The old ignitor was really tight. Take care and spread bracket apart and old ignitor will slide out. The new one goes in the same way.
4 of 5 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
CustomerDerry from Chino Hills CA
Old knob had paited numbers worn off.
I found the exact match replacement knob on Parts Select.com. I ordered it and changed it out !with the old knob and it fit and works perfectly