Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS2162263
This kit comes in two pieces: the catch and the clip.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
The door had always opened with the wrong swing and it wasn't til I needed to repair this that I noticed you could change the swing. I changed the swing of the door and then noticed that the clip was included on both sides so i did not need to repair the catch. I still have the part so when it breaks again, I can just pop it in.
Help other customers find the most helpful instructions.
Were these instructions helpful?
removed the dryer female part that was broken with needle nose pliers and inserted the new one, on the door i removed one phillips screw and r/r the male piece with the new one and re-inserted the screw. that was all, very easy repair
I just inserted the door catch, which by the way fit in perfectly. Thanks. Took 5 seconds to repair.
I inserted the clip
Took off the four screws to get to the female clip and used pliers to squeeze it out. Next was using pliers to pinch out the male connector and place the new one in.
The replacement part just snapped into place. (The old part had fallen out) It took less than 30 seconds to do the repair.
popped up top of dryer -- With pliers squeezed clips on inside of latch - - with screw driver pryed latch out -- just pused new latch in.......... Thanks to parts select for sending part sooo fast.. wife was happy.. Thanks, Dale
First I put the square female end iof the door catch kit nto the square hole as snug as I could. Then I gently pushed the door against the piece until I heard it click in to place. That's it!! Sooooo simple--
I took out the old worn out part and replaced with the one I order.
discovered it was a broken latch. Ordered the latch, only took 2 days to arrive and all I had to do was remove the broken latch and snap in the new one. I saved myself a service call. I'm very happy!!!!!!
Removed power and front panel, removed broken latch, pushed in new latch and replaced the front panel and power. Done
Watch the video. Very, very easy
called SEARS told part not available any longer. Would have to purchase new dryer. Also told part could not be ordered from MAYTAG due to age. Called PART SELECT and had new parts in four days. Put new knob on, Placed door lock in hole, JOB DONE (15 minutes) saved $ 500 to $600 on new one. Wayne
took old one out with needle nose plyers. popped new one in. only issue part ,$3, shipping brought to $10 No excuse
Well tried to find this simple part around Columbus and even maytag website no luck.Parts select had it to go and arrived earlier than expected.Fixed it less than 5 minutes works great.taken longer to put the light bulb back in,Really like the accuracy and quick response from parts select.If I had called a service tech probably would have cost $50.00 or more for a part that cost a little over $3.00 and saved this site in case I need to order other parts.Thank you
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.