Quick Question!

Have you ever purchased from PartSelect.com before?

2121829-1-S-Whirlpool-D7863101-Outer Door Handle Pad
2121829-1-S-Whirlpool-D7863101-Outer Door Handle Pad 2121829-2-S-Whirlpool-D7863101-Outer Door Handle Pad 2121829-3-S-Whirlpool-D7863101-Outer Door Handle Pad http://www.partselect.com/Schematics/Maytag/11955.gif

Outer Door Handle Pad

PartSelect Number PS2121829

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, KENMORE®, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Compare At


You Save


Your Price

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Inner Door Handle Pad

Part Number 2121825

This black inner door handle is the inner most part of a three piece door handle assembly.

No Longer Available

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.3 / 5.0, 2 reviews What's this?
1-2 of 2

2 of 6 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Daniel from Englewood, CO

Handle pads were broken

Remove the three small screws keeping the old parts on The handle then place the new ones on remembering the position that the old were in replace screws .... that's it !

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 2 people found this instruction helpful

Parts Used:
  • Outer Door Handle Pad
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Pliers, Screw drivers
Customer: Jeff from Greenwood, DE

Refrigerator would not cool/freeze

After an hour of searching the wire schematic diagram on the rear of the box , i looked for an obvious problem. Once I learned that this unit has a defrost switch built in in the control panel under the kick plate on the front of the unit, I pulled the large box out to reveal the small control panel with diods and computer chips mounted on the board with 8 wires running to that board, I learned that a mouse had somehow gotten into the box and crawled across the chip board, there he was fried and apparently the current continued to flow through his body and when the deterioration process reach acertain point my Amana decided it would not work. It was a very expensive unit and was told it would last 30 to 40 years with maint. So far it has lasted 17 years. Anyway replaced switch and the front handle of the unit while I had it apart for a good cleaning. The handle was a cinch.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2