Ice Bucket

PartSelect Number PS2120950

This ice bucket collects the ice cubes dropped from the icemaker. The auger is NOT included with this bin.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.6 / 5.0, 4 reviews What's this?
1-4 of 4
 

4 of 5 people found this instruction helpful

Parts Used

  • Ice Bucket

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsNutdriver

CustomerJackalin from Lincoln NE

Old clear plastic bucket cracked after so many years

Took the plastic nut (left-hand thread) a little prying of the auger at the back to dislodge then reverse about
oh yeah, front cover removed from the rear (quarter inch nut driver) works great.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 4 people found this instruction helpful

Parts Used

  • Ice Bucket

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers, Socket set

CustomerMary Kay from Cincinnati OH

Melted ice bucket in dishwasher

Removed a few screws from front of old ice bucket and removed the inside part of the ice bucket. Forced the inside coil thing back into the new ice bucket and then attached the front back on to the new bucket also. The hardest part was manuvering the coil part out and back in - but in general it was a very easy fix.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 4 people found this instruction helpful

Parts Used

  • Ice Bucket

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver

CustomerKENNETH from COLLIERVILLE TN

Old ice bucket had cracked around the auger.

Transferred old auger and faceplate to new ice bucket. Auger was retained by left-handed nut. Faceplate was retained by 1/4" self-tapping screws.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

  • Ice Bucket

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver, Pliers, Socket set, Wrench(Adjustable)

CustomerJoseph from E. Syracuse NY

My ice bucket was broken & the water valves weren't working

I removed the faceplate and auger from the old ice bucket and installed it in the new one(10 minutes). Then removed the water intake valve and replaced it with a new one also ordered from you (about 15 min). The ice maker is working fine as is the water through the door. Very simple job, Ordering was easy and the service was excellent and fast. Thanks again and I've recommended you to my friends.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-4 of 4