| |
5 of 6 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver, Pliers, Screw drivers
CustomerWilliam from Northridge CA
Would not run the full 2 hour cycle also diffcult to get the dishwasher to turn on
First removed the inside door panel which exposed the box that contained the control board. Removed the old control board and replaced it with the new part making sure that the connectors will connecte to the correct place. With the back panel removed I also replaced the latch assembly. Was a very simple job and the dishwasher is working great. Thanks to PartSelect for having the diagram of the dishwasher that help to locate correct parts.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
ToolsNutdriver
CustomerScott from Maryville IL
Dishwasher would run for a few minutes and then shut-off
It seemed like a control unit problem to me, something in the board. It was basically a guess,every once in awhile you get lucky. I took off the inner panel for the door (shut power off to unit!) Removed the control board screws, released tabs on harness connector and changed board out. It works fine now. Rather be lucky than good any day.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsNutdriver
CustomerPedro from Jacksonville NC
Control panel was programed for washing but unit would not start.
Repair was not completed. After troubleshooting all other possibilities for unit not starting the only component left was the control board. Upon replacement problem was not fixed. while doing other inspections found two conductors on the ribbon that connects the control panel to the control board broken.
Please before ordering a control board for a "wont start" condition check the ribbon conductors for a broken circuit. Place a small flashlight beam behind the ribbon to better highlight any breaks.
This ribbon is fragile so be gentle in handling it during the inspection. There should not be any gaps in the "lines" that are actually like wires that complete the connection.
|
1 of 6 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerDaniel from Sonora CA
Original seller stated at least $350 to trouble shoot and repair dishwasher or $600 to replace.
Using a screwdriver, I was able to obtain part numbers from Circuit Board from the inside of the Dishwasher door and confirm the part numbers from your web site. Then, I was able to order an $88 part and repair the dishwasher.
|