| |
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerKen from Opelika AL
Broken handle
Removed inside panel with torx screwdriver maybe 8 screws. Pop new handle in from front side of switch only. Replace panel and start dishwasher.
|
1 of 4 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsNutdriver, Socket set
CustomerJoseph from Dover DE
Touch pad inoperable and latch hande & latch broker
Disassembled inside door and replaced sensor board and latch devide and handle. I removed all the screws on the inside of the door, released the circut board(sensor board or control board) and removed each connection one at a time and pluged them one at a time into the new board. I studied the setup before I disconnected anything. Oh yes, I turned off the breaker in the basement before opening the panel on the inside of the door.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
Tools
Customerray from marietta GA
Latch broke
removed inner panel of door
removed old latch
replaced with new latch
replaced inner panel
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerBlair from Germantown TN
Latch handle broken
First removed around 5 screws.
Then took inside door panel off.
Pulled out the piece that housed the door latch.
Replaced part, and put the door panel back on and tightened screws.
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerTom from Cottonwood CA
Plastic handle broke
I ordered only the plastic handle at 1st (wrong); I re-ordered it as electrical and found the whole piece needed replaced, the plastic handle was not available.
When I got it, I already had everything out and ready; it took approx. 10 minutes to put everything back and running. Very Easy!!!
Thanks
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerAmy from Subiaco AR
Latch broke
Took the inside door panel off by taking out the screws. Removed the broken latch, replaced it with the new. Replaced the door panel. Saved ourselves a service call. My husband is handy and can fix most anything.
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsWrench set
CustomerJohn from Freehold NJ
Handle was broken
Although there were no directions, I was able to figure out that you needed to take out all of the screws that hold the front panel on. Once I opened the front panel, the old handle fell out, so I wasn't sure how the new handle went in. In a couple of minutes, I figured it out and it is now fixed.
|