2099991-1-S-Whirlpool-99002643-Manifold Mounting Bracket
2099991-1-S-Whirlpool-99002643-Manifold Mounting Bracket 2099991-2-S-Whirlpool-99002643-Manifold Mounting Bracket 2099991-3-S-Whirlpool-99002643-Manifold Mounting Bracket

Manifold Mounting Bracket

PartSelect Number PS2099991

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Not cleaning properly.
  • Compare At

    $5.35
  • You Save

    $.89
  • Your Price

    $4.46
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.2 / 5.0, 3 reviews What's this?
1-3 of 3
 

8 of 12 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerHarry from Bensalem PA

Detached water distribution manifold

The original brackets that hold the water distribution manifold to the back and top of the tub came off the "X-shaped" plastic posts on the tub walls. That caused the upper wash arm to sag down into the travel of the upper dish rack and was broken off when the rack was pushed in.
I bought 2 new brackets and a new wash arm. The new brackets had a smaller aperature than the originals and fit tightly onto the plastic posts, holding the manifold firmly in its proper location. Replacement of the brackets and the new wash arm took less than ten minutes and required no tools!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers

CustomerBLAKE from OLATHE KS

Dishwasher not cleaning correctly

Hey I hope this helps someone.. I was quite frustrated with out little dishwasher. It almost seemed that the dishes would come out dirtier than when they went in. Turns out we have hard water and it did a number on the parts of the dishwasher. Luckily, the parts were cheap enough that I thought I would give em a try. Between that and something called "Dishwasher Magic" I had success! One thing I wished I did differently was that I should have purchased two (2) wash arm retainer clips... I re-used an old one but it would have been nice to have all new parts inside.
Needless to say, our dishes now are super clean. I have 6 young kids so our dishwasher gets a real workout. I may have to purchase a water softener down the road but for now we'll roll the dice.

Hope this helps!

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 12 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerDennis from Eaton Rapids MI

Racks rusted ,mounting bracket broken, seal leaked

replaced racks easy, pulled dishwasher out to replace seal and used pro-apoxy to secure bracked to washer, as both brackets were lose and would not clip in location.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3