Tub Wheel

PartSelect Number PS2099579

Sold individually. This part mounts on the side of the tub. The shaft or screw that holds in place is sold separately.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $8.42
  • You Save

    $1.40
  • Your Price

    $7.02
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Tub Wheel - NOT a Rack Wheel

Part Number 2100247

This wheel attaches to the inside of the tub to help guide the track and support the top rack.

$6.51
In Stock

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 3 reviews What's this?
1-3 of 3
 

7 of 7 people found this instruction helpful

Parts Used

  • Tub Wheel

Level of DifficultyEasy

Time to do repair:15 - 30 mins

Tools

CustomerSteve from Boston MA

Upper carriage wheels broke.

The only tricky part was fixed by reading another post on this website -- removing the plastic endcaps on the steel sliding brackets. This is a necessary step before replacing the wheels because the bracket needs to slide between two fully installed wheels.

To remove the endcaps, you must push the flat end of the endcap (the side of the endcap facing you) sideways toward from the dish carriage, with your thumb. Once that slides sideways, the entire endcap can be easily pulled from the bracket. Not much force is required for either step in removing the endcap. If you look closely at the endcap, there is an arrow to show the direction in which to slide the flat portion.

The wheel can be bumped onto the wheel axle by placing a wooden block against the outside of the wheel and then applying a gentle tap of a hammer to the block. Use a flashlight to make sure the wheel hub rests against the washer tub sidewall.

Help other customers find the most helpful instructions.

Were these instructions helpful?

7 of 9 people found this instruction helpful

Parts Used

  • Tub Wheel

Level of DifficultyEasy

Time to do repair:Less than 15 mins

Tools

CustomerFleet from Olympia WA

Tub wheel wouldn't stay on

Took off old, snapped in new.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 6 people found this instruction helpful

Parts Used

  • Tub Wheel

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerWilliam from Santa Fe NM

Tub rollers worn and falling off the mounting pins

The most difficult part is learning how to unsnap the plastic retainers at each end of the steel sliders on each side of the dish rack. Push the end caps to the outside and the plastic inserts will snap open and slide off the ends of the rails in two pieces (note how they were oriented so you can replace them later). The caps must be removed from both ends of each rail. Slide out the basket. slide the rails out. Pull the old rollers off the pins. Place the new rollers into position. A smart rap with the palm of your hand should snap the rollers onto the pins. If you have done it correctly, the rollers will not pull off the mounting pins. You could also place a small block of wood against the roller and use your hand or a small hammer or weight to snap the pins into place. Assemble in reverse order.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3