2099565-1-S-Whirlpool-99002169-Decorative Outer Door Panel
2099565-1-S-Whirlpool-99002169-Decorative Outer Door Panel 2099565-2-S-Whirlpool-99002169-Decorative Outer Door Panel

Decorative Outer Door Panel

PartSelect Number PS2099565

This stainless steel panel is not reversible and may also come with a white protective film over it.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Outer Door Panel

Part Number 2099020

This is not a reversible panel.

$103.48
In Stock

Decorative Outer Door Panel

Part Number 2099019

This is the white outer door panel only. It is not the complete door assembly. This panel is not reversible.

$63.77
In Stock

Outer Door Panel - Bisque

Part Number 2099510

$34.11
No Longer Available

Access Panel

Part Number 2099598

Part might come with a white protective film - just peel off film before installing part. ***Screws are sold separately.

$128.98
No Longer Available

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.5 / 5.0, 2 reviews What's this?
1-2 of 2
 

5 of 8 people found this instruction helpful

Parts Used

  • Decorative Outer Door Panel

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerDebra from Williston Park NY

Wanted to chnage dishwasher panel to match stainless appliances

Open the door all the way. Remove the 7 screws along the perimeter with a Torx screwdriver. Then close the door. Remove the two screws at the bottom of the side of the outside of door panel with a phillips. With the palms of your hand flat on the panel slide the panel up about 1/2 inch and it falls toward you. Follow these steps in the opposite direction to install the new door. I did however replace the two phillips screws last.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 5 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsPliers, Screw drivers

CustomerBrian from Estes Park CO

The hardest part was getting the old board out without breaking it

I unscrewed the 8 star head screws on the inner door panel and the 2 screws on the outer edge of the door, then the 2 screws on the door handle and it all opened up to the control board. Next I unscrewed the 2 screws holding the board and removed it, then disconnected the wire plugs to replace the board. At this point it was just a matter of reversing the sequence events.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2