2099565-1-S-Whirlpool-99002169-Decorative Outer Door Panel
2099565-1-S-Whirlpool-99002169-Decorative Outer Door Panel 2099565-2-S-Whirlpool-99002169-Decorative Outer Door Panel http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/52888.gif

Decorative Outer Door Panel

PartSelect Number PS2099565

This stainless steel panel is not reversible and may also come with a white protective film over it.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Outer Door Panel

Part Number 2099020

This is not a reversible panel.

Order within the next 1 hr and 37 mins and your part ships today!
$104.96
In Stock

Decorative Outer Door Panel

Part Number 2099019

This is the white outer door panel only. It is not the complete door assembly. This panel is not reversible.

Order within the next 1 hr and 37 mins and your part ships today!
$65.08
In Stock

Outer Door Panel - Bisque

Part Number 2099510

$34.11
No Longer Available

Access Panel

Part Number 2099598

Part might come with a white protective film - just peel off film before installing part. ***Screws are sold separately.

$134.04
No Longer Available

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.5 / 5.0, 2 reviews What's this?
1-2 of 2
 

6 of 9 people found this instruction helpful

Parts Used

  • Decorative Outer Door Panel

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerDebra from Williston Park, NY

Wanted to chnage dishwasher panel to match stainless appliances

Open the door all the way. Remove the 7 screws along the perimeter with a Torx screwdriver. Then close the door. Remove the two screws at the bottom of the side of the outside of door panel with a phillips. With the palms of your hand flat on the panel slide the panel up about 1/2 inch and it falls toward you. Follow these steps in the opposite direction to install the new door. I did however replace the two phillips screws last.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 5 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsPliers, Screw drivers

CustomerBrian from Estes Park, CO

The hardest part was getting the old board out without breaking it

I unscrewed the 8 star head screws on the inner door panel and the 2 screws on the outer edge of the door, then the 2 screws on the door handle and it all opened up to the control board. Next I unscrewed the 2 screws holding the board and removed it, then disconnected the wire plugs to replace the board. At this point it was just a matter of reversing the sequence events.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2