2099286-1-S-Whirlpool-99001793-Suction Plate
2099286-1-S-Whirlpool-99001793-Suction Plate 2099286-2-S-Whirlpool-99001793-Suction Plate http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/50012.gif

Suction Plate

PartSelect Number PS2099286

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Not cleaning dishes properly.
  • Compare At

  • You Save

  • Your Price

In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.4 / 5.0, 2 reviews What's this?
1-2 of 2

6 of 6 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

ToolsNutdriver, Screw drivers

CustomerRobert from Tabernacle, NJ

Heard noise shorty after starting to run. Seemed to get worse at times in short time frame

Located circuit breaker for dishwasher and turned off breaker to secure power going to unit. Removed water spray bar arm inside dishwasher basin by unscrewing center nut and unclipping tabs against arm. Removed sheet metal access panels on bottom front of unit. Removed two individual plug in wires to temperature thermister. Removed 4 conductor plug wiring going to motor. Removed ground wire going to motor frame. Located plastic handle which cam locks motor / pump assembly into place. Pulled handle down gently to unlock from detent and turned clockwise to release pressure on assembly. Removed motor / pump assembly from dishwasher enclosure. Installed all new parts purchased as listed above utilizing parts breakdown aquired from PartSelect.com. Reinstalled motor / pump assembly in reverse order as listed above. Tested and ran unit with no problems. Thank You PartSelect.com, Robert.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers, Socket set

CustomerTodd from Albuquerque, NM

Loud whining noise immediately after draining

Removed all parts down to wash impeller following online videos and parts breakdowns (took a while to figure out how to do this). The only difficult part was separating the Discharge Pump housing from the Suction Plate. They are fitted together with friction, and a flat-blade screwdriver can push them apart. Replaced broken parts including Wash Impeller, Suction Plate, and Discharge Pump Housing. Purchased Filter Support because it was involved and appeared to have been damaged, but the new part looks identical to the old part. Purchased new o-ring & gasket to avoid digging them out of broken parts. Cleaned out the spray arms top & bottom and it now works like new!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2