2099035-1-S-Whirlpool-99001434-Fold-Away Tine - Front
2099035-1-S-Whirlpool-99001434-Fold-Away Tine - Front

Fold-Away Tine - Front

PartSelect Number PS2099035

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Fold-Away Tine - Rear

Part Number 2099036

$23.41
Special Order

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.1 / 5.0, 3 reviews What's this?
1-3 of 3
 

1 of 3 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

Tools

CustomerJohn from Matthews NC

Jennair dual end combination retainer clip was not available. Jenn-air redesign parts and their redesign contains tines no longer available.

Rail and Rack assembly items 2, 3, 4 and 5 have been reengineered for my model JDB2100AWS dishwasher. My dishwasher does not have the tines snapping into the rack assembly front and rear sides. They are free standing held in place with a one dual end combination retainer clip and pivot clip that snaps on the rack assembly bottom mesh. Jenn-air tines were not available. I thought Matag Tines may work.

The Maytag tines P/N PS2099035 and PS2099036 will not work without some modification to the parts (i.e., bending and cutting) and the color does not match (i.e., light gray vs. dark gray). However, they did provide the insight to modify the existing Jenn-air tines. This may help other customers.

Modifying the existing Jenn-air tines:
1) Install the latch parts below.
2) Position the existing tine vertical member in the latch.
3) Mark the horizontal bar end that will extend outside of the rack to be cut (about 1/2").

Note: Follow good safe practices when cutting the metal tine. Recommend using a Dremel tool and vice to secure the tine.

4) Cut the tine horizontal bar end that extends outside of the rack (about 1/2").
5) Install the parts.

Parts used and available:
#4, P/N 99003190 (LATCH, FOLD AWAY TINE (FRT)) - QTY 1
#4, P/N 99003189 (LATCH, FOLD AWAY TINE (REAR))- QTY 1
#5, P/N 99003188 (PIVOT, FOLD AWAY TINE) - QTY 4

If needed, I can e-mail you a photo of the final assembly.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerRichard from Mansfield OH

Rusty and broken parts

The repair to the lower wash rack could be done with my fingers. Purchasing 4 parts was cheaper than buying a whole new rack.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 3 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerJohn from Roswell GA

Dishwasher rack broken

I just had to line up the two rack holders and snapped on the latch to each rack as well as to the back of the sliding dish holder.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3