2099032-1-M-Whirlpool-99001429-Upper-Rack-Shelf.jpg
2099032-1-S-Whirlpool-99001429-Upper-Rack-Shelf.jpg 2099032-2-S-Whirlpool-99001429-Upper-Rack-Shelf.jpg 2099032-3-S-Whirlpool-99001429-Upper-Rack-Shelf.jpg

Upper Rack Shelf

PartSelect Number PS2099032

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $34.52
  • You Save

    $5.75
  • Your Price

    $28.77
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.3 / 5.0, 4 reviews What's this?
1-4 of 4
 

65 of 68 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerThomas from Centennial CO

Old shelf rack and silverware basket (yellowed & stained)

Removed the old dishrack shelf by taking off the end caps. A screw driver was used to release the plastic end caps. The old dishrack shelf is now able to just roll out and the new shelf is rolled in and the old end caps replaced. Quick and easy plus it makes the dish machine look new. The new silverware basket requires no tools just replace the old one.

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 6 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:15 - 30 mins

Tools

CustomerPeter from Andover MA

Rusty movable shelf racks

Since there are no nuts or anything else to remove on these racks, bending them into place is the only obvious way to go to fit them onto the existing racks. Taking out the old movable racks is the easy part - just take a pair of pliers and bend back the 'O' part of the movable rack where it goes over the pin on the big rack. To put on the replacement racks, I found that I had to bow the racks in the middle to make them fit. Simply pressuring them into place didn't have enough give. With a helper to hold the big rack steady, I could use 2 hand to bow and align the movable racks and snap them into place. You have to be careful not to bow to much or you could permanently bend the new parts. I broke one weld between the short pieces that go perpendicular to the long wires on the new rack by putting too much pressure on the long wires.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerJoel from New Rochelle NY

Replacing 2 parts, one of which had broken, needed replacing

Both parts were easily replaced without the use of any tools. Just slipped into place.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 2 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerDaniel from San Diego CA

Shelf/rack rusting out

Remove end stop. Slid rack from track. Replaced with new rack. Re-installed end stop.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-4 of 4