| |
6 of 10 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers
CustomerJEFFREY from WAVELAND MS
The spray diverter assembly came off and fell on the heating element and melted.
FIRST I INSTALLED THE SPRAY DIVERTER,THEN I INSTALLED THE DISCHARGE HOUSING NUT AND TIGHTENED IT DOWN. LAST I SNAPPED ON THE SPRAY DIVERTER CAP.
|
4 of 9 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:30 - 60 mins
ToolsNutdriver, Pliers, Screw drivers, Socket set
CustomerJohnny from Paducah KY
Discharge housing backing plate broke off
From the inside I removed all of the accesories down to the impeller . I replaced the impeller as a precaution measure just incase any wear from the backing plate of the dischareg housing coming undone. and reassembled the unit. It is very easy if you have a repair manuel. I received my parts the next day. Great company
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
Customergeorge from atkinson NH
Hole in spray diverter
just put the three parts together . I had the old parts to go by .
You have a terrific web site for research into exact parts needed for any appliance Keep up the good work !
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerKris from Mohrsville PA
The cap sprayer fell off and melted during a cycle
I placed the distributer cap on and tightened with the housing nut and snapped the cap on and it was fixed. Very easy, no tools involved.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers, Socket set
CustomerMark from Schenectady NY
Loud grinding noise
We heard a horrible grinding noise just after starting the machine TWO DAYS before Christmas. On a whim, I disassembled the lower spray arm assembly right down to the wash impeller. I ran the dishwasher and heard no grinding noise, so I knew it wasn't a problem with the motor/bearings. After taking out the old parts, I noticed the discharge pump housing was in two pieces, and judging by the look of it and how those two pieces were fitting together, felt something must be wrong with them. I ordered a new discharge pump housing unit and a few extra parts just to be sure, and after 30 minute install of the new parts, the dishwasher is back to life. A $65 shot in the dark repair by a non-repairman vs. a new dishwasher... I'll take the shot in the dark. Thanks PartSelect!! I'm on to ordering a new utensil basket now!!
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers, Socket set
CustomerGeorge from Red Hook NY
Unit sounded like it was trying to start then would shut off.
I removed the lower spray arm, then the cover over the discharge housing. Then removed the discharge housing,and the wash impeller.
I reassembled in the reverse order of the disassembly,with a new discharge housing nut,housing gasket,and lower spray arm seals.
|