Gasket Kit

PartSelect Number PS2097044

This gasket kit comes with the fasteners and screws.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Leaking water.
  • Compare At

    $31.07
  • You Save

    $5.18
  • Your Price

    $25.89
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.3 / 5.0, 2 reviews What's this?
1-2 of 2
 

13 of 19 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:More than 2 hours

ToolsNutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)

CustomerGregory T. from Pittsburgh PA

Noticed a water growing water spot downstairs under the dishwasher .

I pulled the dishwasher out & watch it complete 1 cycle : water was leaking at a through hole used to secure the upper dish rack roller to the cabinet : the nut & seal holding the roller was loose allowing water to drip down the outside of the cabinet under the insulation.: water dripped onto the belt causing belt to slip : many water marks around the pump ; as a precaution i replaced the pump bottom seal & the pump to chassis gasket : I also checked the other 3 rolles ; replaced cracked top flange & installed a more flexable water supply hose .

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 9 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsNutdriver, Socket set

CustomerMike from Seaford NY

Loud grinding noise on rinse cycle, water not draining

Turned off the circuit breaker. Removed the two lower panels below the door. Removed the two racks from inside the tub. Removed the lower rinse arm, then unscrewed and removed in stages as much of the washer components from the inside bottom of the tub. Last item was the unit that screws into the base of the tub, was loose but would not come out, then I realized I needed to disconnect the water lines from underneath the tub. Then I was able to lift the pump/motor assembly out from inside the tub. Disassembled that until I reached the wash impeller, and saw that the shaft was no longer rectangular, but rounded out and spinning freely which was why the water was not being pumped out. Also found a small flip top from a can, no idea how that got down there, but that was what was making the loud scraping noise as the was impeller tried to spin. Reassembled everything and unit now works fine (and much quieter!) Never had to take the dishwasher out from under the cabinet and if I had to do this again it would only take 30 - 40 minutes - live and learn!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2