Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS2094592
This part sends enough current to the igniter to create a spark to the bottom of the burner cap.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
remove small panel on right side of stove,then un clip moduke and put wires from old module to new one.Exact fit nomproblems.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Replaced spark module but same problem persisted. Realized that the insulation on the spark ignitors were all cracked, causing a short. Lesson learned: check the condition of the spark ignitors first as these have a tendency to crack. Even the smallest crack will cause a short. Ordered new spark ignitors and plan to complete repair.
Shut off gas supplyPulled stove away from wall removed spark ignigtor box .Installed new one .No problem.Good for another 10 years
Removed grill and set aside, then removed burner with a 1/4 counter clock twist. Removed ground wire and igniter wire from burner. Set to side in order taken off. Remove the two screws on the panel that is on the back of the unit and slide it up and set it aside. Removed screws from side decorative panels each side (one top and one bottom) and slide panel toward the rear to remove from notch slot. Then removed the two screws on each side and back to remove top of range. On the side there are two screws together towards the rear, the one towards the front of the range need to be removed. Then removed four screws that held the pan under the range top that were screwed into the gas line supports. Then removed the two screws from rear that held the pan in place. Remove the pan and set aside. Lift the right gas line burner support up. Remove ground bottom, hot wires upper and igniter wires from spark module. Pop module out and replace with new one. Reverse process to complete repair. Cause that the wires do not get under the pan when reinstalling same
cut off terminals and replaced with the right size one's stove lights every time now wlrowe
The trickiest part was locating the elusive spark module. I am not certain I took the best route, but not considering all the wrong routes in trial and error, it was the most expedient. Certainly there must have been a single something to remove to get to this frequently faulted part..Anyhow, thanks to the great part, the stove works really well again.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.