7 of 13 people found this instruction helpful
- Burner Spark Ignition Switch
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Pliers, Screw drivers
Customer: Roman from West Caldwell, NJ
Igniter switch on the burner was constantly on
To get to the switch I had to remove the knobs and the front panel of the burner valves. There were some dozen screws, top and bottom holding the panel in-place.
The switch slid off the burner valve stem easily but removing the wires I had to pull with the pliers. There seamed not to be a wire release that I could see.
Replacing the wires was no problem. They slid into place by just pushing them in. Assembly was the reverse.
1 of 6 people found this instruction helpful
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Customer: Mark from Hastings on Hudson, NY
Burners would no longer work without using a match or lighter
I replaced all the burner switches as well as the spark ignition module. It was necessary to solder small terminals to use the existing wires with the new spark ignition module. Otherwise, this was a pretty straightforward job. My wife, an excellent cook, is now even happier than usual.