1 of 7 people found this instruction helpful
Level of DifficultyVery Difficult
Time to do repair:1- 2 hours
ToolsNutdriver, Pliers, Screw drivers
CustomerGraham from East Troy, WI
Conversion to lp gas
Screws that hold the burners in place where rusted and the tops broke off, After breaking the tips of two cross screwdrivers, result was that I had to drill out old screws and re tap new holes into the base of all the gas outlets. As this was a second hand stove. I am not sure what cause the screws and the gas outlets to become extremely rested. It should of been possible in my mind to just insert a tool and remove the pilots, But three of the burners only has small openings, so it was not possible to do this, A three minute job, took well over an hour.