| |
4 of 5 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerTHOMAS from BOWIE MD
Needed to replace indicator light after original had been broken when a pot fell and shattered the lens.
Removed the two screws holding the switch/indicator lights panel in place. After removing the two wires from the old indicator light, i removed the broken light, installed the new one, and reconnected the wires. It was then I discovered there was a spring clip that holds the indicator light in place, it had fallen into the area where the filter is kept. I had to remove the wires again, install the clip, reconnect the wires, and install the two screws holding the light panel in place. It would have been helpful to have a short description of the process included, which would have eliminated the need to remove the wires a second time to install the spring clip. The clip is essential to hold the indicator light in position and prevent it from moving.
|
4 of 6 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Pliers
CustomerThomas from Moneta VA
Fan switch and indicator lights disintegrated
Turned off the power. Removed the assembly with two screws then removed the switch with two screws. Pulled off the wires. Put on the new switch and lights and reconnected the wires. Reattached the assembly. Turned on the power. All OK.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsScrew drivers
CustomerEva from Killeen TX
One of our indicator lights came broken when we purchased the cooktop
We removed all the screws in order to remove the top cooktop frame. Once we did, the bottom part of the cooktop fell! It was being held up by the vent that goes underneath. My son and I had to get underneath to push up while my husband tried to position the cooktop back over the counter top ledge. It was VERY heavy. This was difficult and needless to say, it fell a couple more times before we finally were able to keep it on the ledge. We had to turn off the electricity, pulled the element out and disconnected the two wires, installed the new light and then placed the cooktop cover back in place by screwing all the screws. We did test the light before screwing on the cooktop cover JUST in case...:) It worked!
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:1- 2 hours
ToolsPliers, Screw drivers
CustomerJavad from Shingle Springs CA
Fan switch burnt and red light indicator broken
The switch did not fit in and had to be returned.
|
0 of 3 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers, Wrench set
CustomerThomas from Grant NE
Surface burner switch failed, and so did red light indicator.
I disassembled the stove top and replaced the components.
|