Door Handle

1st removed the door from the hinges by sliding it up. Then removed all the screws holding the door together. Then removed the screw securing the trim. Removed the screws from inside the trim holding the old handle... replaced the handle and trim. replaced all screws in reverse order. Replaced the door on the hinges. all done

I removed the screws from the top of the door, the sides and the bottom of the door. I still couldn't get the door to come apart because there were screws on the inside. It took me about 10 minutes to figure out that I had to slide the glass plate off the front of the door to get at the screws on the inside. Once that was done, I was able to replace the handle without problem. The only other thing is that I cut the top of my index finger while trying to clean the door before I put it back together. I was careful to keep track of which screws went where because otherwise it would get confusing. My handle looks and works great! Thanks

I REMOVED THE DOOR, THEN REMOVED THE 5 SCREWS HOLDING THE BOTTOM AND SIDE TRIM ON. I SLID THE TRIM DOWN WITH THE GLASS FRONT. THIS EXPOSED THE SCREWS HOLDING THE TOP TRIM ON. I THEN REMOVED THE 8 SCREWS HOLDING THE TOP ON. AT THIS POINT I TOOK THE OPPORTUNITY TO CLEAN THE THREE LAYERS OF GLASS. I THEN PUT THE NEW HANDLE ONTO THE TOP TRIM, THEN INSTALLED IT, THEN RE-ASSEMBLED THE DOOR AND PUT IT BACK ON THE STOVE. IT TOOK ABOUT 30 MINUTES INCLUDING CLEANING. SIMPLE!

well relatively easy, I removed the oven door, took off broken and worn parts. Cleaned door, because it needed it, installed new parts and everything thing fitted perfectly. Thanks for having what I need on hand. The prices were good as well. I will be purchashing from you again. Thanks.