| |
2 of 3 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerShaveta from Sterling VA
Electric range oven's element wouldn't heat up and dishwasher's upper rack wont roll out
The sketches on PartSelect.com were very-very helpful, in picking up the parts to order and also while fixing the parts.
For oven range. First I removed the two screws that hold the flat top in place and lifted the flat top. I then unscrewed the two screws that holds the element kit. Disconnected the three wires, and replaced the broken element with the new one. All done.
For dishwasher, just snapped the parts in and all set.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:30 - 60 mins
ToolsScrew drivers
Customerbrian from waukesha WI
My oven wouldn't always properly pre heat
It was real easy I took the wire racks out then the bottom cover. The ignitor was right there. The two screws took a little to get out for rust. i pulled the wire up and disconnected the old unit and connected the new one the put everything back together
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerRichard from Davenport FL
Broken control panel ends
slid out the range removed the old replaced it with the new. very easy repair
|