| |
6 of 6 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerMarshall from Gray TN
Broken glass on cooktop
Simply removed screws holding glass and frame to cook elements and replaced with new glass and frame.
The replacement was very easy. The glass and frame come as a unit.
I also purchased a complete element assembly. Replacing the element assembly requires no tools and no work ... simply remove broken assemply and place new assembly into the range.
|
6 of 6 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers, Screw drivers
CustomerSusan from San Diego CA
Two of the surface unit infinite switch d-shaped pins were broken
following the directions in the package and on-line, this repair was easier than i could have imagined. changing out these two parts took less than 15 minutes.
|
4 of 5 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerDarla from SULPHUR LA
Knobs on stove where wore to the point I could not see the numbers for the temp. Easy replacement
Very easy just pulled off old knobs and replace with new ones,
|
2 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerLois G from Baltimore MD
Degrees were illegible.
I removed the old knob and replaced it with the new Maytag knob which worked.
I was especially pleased because another website had listed the part as unavailable, and a local parts store said they could not help me. Our range is at least 30 years old.
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerJune from Russellville KY
Nubers worn on thermostat knob
Ordered new one, it came, and I put it on. The hard part was finding the model number,
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerJoyce from Brandywine MD
On/off switch for down draft exhaust
The old switch had already been removed after it began to smoke, by removing two screws and removing the electrical wires. I then replaced the wires back into the new switch, replaced the two screws and all done. By the way, this was the first repair to this stove, which is well over 30 years old. Believe it or not!!! It still works like a champ and doesn't look a day over 5 years old. It pays to buy quality doesn't it? Joyce Gregory
|