http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/56193.gif
See part 14 in the diagram

Dispenser Facade Insert - White

PartSelect Number PS2068008

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $26.53
  • You Save

    $4.42
  • Your Price

    $22.11
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.1 / 5.0, 3 reviews What's this?
1-3 of 3
 

34 of 37 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

Customertom from lawrence KS

The touch pad cover was cracked

I ordered the cover and the face plate because I was unsure of the condition of the cover and because the face plate is stuck on the cover. The repair was very simple. Turn off power to unit. Remove the spill plate, it just pulls out. Then remove the two screws that are seen when the spill plate is pulled out. The cover slides down and comes out. Disconnect the two wires to the operator switch, they just pull off. Take two small screw drivers and gently raise the tabs that latch in the circuit board jack and pull the jack down to remove it. Remove the one screw that secures the circuit board and use a small screw driver to gently raise the tabs that hold the circuit board in place on the bottom side and remove the circuit board. Install the circuit board on the new cover and intall the holding screw. Plug in the jack that connects the circuit board to the unit. The plug in the two wires to the microswitch. Install the cover and install the two holding screws. Slide in the spill plate. Finally install the face plate, it just sticks on and is very easy because the cover is resessed where it is to be installed. In all I think it took me longer to wright this than it did to do the repair.

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 6 people found this instruction helpful

Parts Used

  • Dispenser Facade Insert - White

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

Tools

CustomerRobert from East Providence RI

Facade face plate was broken.

This was a fairly easy and straightforward repair that simply involved removal of the old facade face plate by pealing it off and sticking the new one in it's place. The worst part was removing the adhesive from the old facade before I could stick the new one on in its place. Perhaps you could include some advice on how to remove the adhesive. I used Goof-off, but was concerned about it attacking the plastic surface. It seemed to work OK.

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 9 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:30 - 60 mins

ToolsScrew drivers

CustomerJose from Floresville TX

Water - ice dispenser not working

Took lower plate out then removed two screws. Unhooked electronic control board and remove board by removing two small screws. Disconnected wires and replaced with new board. Front cover plate was replaced as the "water - crush - cube buttons on face plate had cracked. Replaced front cover with new plate - used a little glue to keep the small buttons in place. Now we can select all three items and it is working fine.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3