http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/56007.gif
See part 13 in the diagram

Damper Control

PartSelect Number PS2067828

This part helps regulate the freezer compartment temperature.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Unusual Noise.
  • Fridge section too warm.
  • Compare At

    $60.77
  • You Save

    $10.13
  • Your Price

    $50.64
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.3 / 5.0, 6 reviews What's this?
1-6 of 6
 

8 of 10 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerDavid from Billerica MA

The control damper was very noisy.

I started by unplugging the unit, then removing the air outlet cover, then the housing & foam insulation. Next ,I disconnected the harnesses & unsnapped the damper assy., & put the new one in. Total repair time was about 10 minutes. I did buy the repair manual, but it was special order & arrived after I made the repair. I am an automotive technician, & this was a very simple repair for me.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 4 people found this instruction helpful

Parts Used

  • Damper Control

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers

CustomerRODOLFO from EDINBURG TX

Refrigerator was not cooling. Damper would not open.

Removed damper vent by hand and then unscrewed 2 visible screws that hold Damper Control Unit in place. After removing screws, the damper control unit is easy to remove by unplugging 2 electrical connectors by hand and connecting new unit the same way. Screw the panel and snap the vent back in place and you're done!! Piece of pie, easy as cake...Ha! Ha!

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 5 people found this instruction helpful

Parts Used

  • Damper Control

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerWilliam from Meredith NH

Damper wouldn't open in referigerator

Removed pop off plate inside top of refrig.
Removed 2 screws holding cover.
Removed cover and styrofoam piece
Unplugged wiring
Removed old part
Transferred wiring to new part
Replaced all parts.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

  • Damper Control

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerChristopher from Homosassa FL

Damper control was noisy when running.

Undid the screws holding cover. Popped out unit and changed the wires from old unit to new and put back together. Very easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 11 people found this instruction helpful

Parts Used

  • Damper Control

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers

CustomerHERMAN from PENN YAN NY

Noisy damper

VERY SIMPLE, TURNED OFF POWER-REMOVED COVER-UNITE IS HELD WITH CLIPS-REMOVED WIRES-AND INSTALED NEW UNITE ,REVERSING REMOVAL PROCESS. GREAT SERVICE. THANK YOU

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

  • Damper Control

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerChris from Santa Barbara CA

Noisy air damper

Removed air damper cover, unscrewed two phillips screws in foam cover, disconnected wire connectors and installed new air damper.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-6 of 6