2065944-1-S-Whirlpool-67001503-Crisper Pan - Large
2065944-1-S-Whirlpool-67001503-Crisper Pan - Large 2065944-2-S-Whirlpool-67001503-Crisper Pan - Large 2065944-3-S-Whirlpool-67001503-Crisper Pan - Large http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/32219.gif

Crisper Pan - Large

PartSelect Number PS2065944

Sold individually.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $63.49
  • You Save

    $10.58
  • Your Price

    $52.91
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.9 / 5.0, 22 reviews What's this?
1-5 of 22
 

196 of 279 people found this instruction helpful

Parts Used

Level of DifficultyReally Easy

Time to do repair:Less than 15 mins

Tools

CustomerStanford from Bowling Green, KY

The crisper drawer was broken on the slides and kept falling out. Also the filter needed changing as the red light was on.

By sliding the drawer out and lifting it up at the end, the drawer will come right out. By installing the new drawer in the same sequence, the job is completed. As for the filter, it is located inside the refrigerator compartment on the upper right side.Simply remove any items from the top shelf that may be in the way, and then push in on the tab that extends out from the filter housing. The filter and connector will swivel down at that point,simply hold the connector in one hand to stablize and with the other hand, twist the filter counter-clockwise to remove the filter. To reinstall the new filter, remove all protective covering from filter. Plase filter against filter connector and turn until tight (1/4-1/2 turn).Raise complete assemble upwads until tab snaps back into place. Installation is now complete, next purge the air out from water supply by placing a pitcher or other large container under the dispenser and activate.Run water for a minute or so until all air is removed.

Help other customers find the most helpful instructions.

Were these instructions helpful?

15 of 19 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerMichael from Omaha, NE

Ice maker leaking

Replacing the icemaker was easy. I unplugged the icemakers wire harness from the refrigerator and then removed three screws. Installing was the reverse of the procedure. I just lined up the single screw of the bracket and the track, reinstalled the three screws and then plugged the icemaker back in. Took less than 15 minutes. After the icemaker got to the right temperature (about an hour) it was making ice again.

I removed the auger, cap, and crusher assembly from the ice bin, by removing the top 2 screws with a small nut driver. Put these parts on the new ice bin and tightened the 2 screws/nuts at the top of the bin and slid the ice bucket back into place.

Help other customers find the most helpful instructions.

Were these instructions helpful?

7 of 7 people found this instruction helpful

Parts Used

  • Crisper Pan - Large

Level of DifficultyReally Easy

Time to do repair:Less than 15 mins

Tools

CustomerJeffrey from Elburn, IL

Large crisper drawer cracked and broke so I could no longer push the crisper drawer in and out

I removed the old crisper drawer, took all the fruits and veggies and put them into the new crisper drawer, and then slid the new crisper into position. If was the exact size and part I needed.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 4 people found this instruction helpful

Parts Used

Level of DifficultyReally Easy

Time to do repair:Less than 15 mins

ToolsPliers

CustomerKay from MANKATO, MN

Light switch had broken off and so the light would not go on when the door was opened. Vegetable crisper drawer had broken along the sides.

We unplugged the refrigerator, used a knife to pry out the old switch. Cut the extra prong off of the new switch and connected the switch to the wire connectors. Slid the switch back into place plugged the refrigerator back into the outlet and . . . . . . Wah, lah, the light and switch worked again. We washed and then simply slid the vegetable crisper into the holder and replaced the one that had broken. This was a really great experience and it was quick and easy to fix on our own.!

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 5 people found this instruction helpful

Parts Used

  • Crisper Pan - Large

Level of DifficultyReally Easy

Time to do repair:Less than 15 mins

Tools

CustomerUrsula from Oconomowoc, WI

Too much weight in the crisper and I cracked off ther part that slides into the drawer guides.

I simply needed to replace the drawer. Customer service Really Is Customer Service at this company! The young lady with whom I spoke on the phone was courteous, knowledgeable and efficient. She knew what I neeeded from my rather inept description. I was told the drawer would arrive in 10 to 12 days, but I actually received it in 3!!!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-5 of 22