| |
10 of 14 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsPliers, Screw drivers
CustomerGreg from Highland Village TX
Ice dispenser acting irradically
Simple to fix. Watched the video and noted what to do.
Replaced the control board, solenoid, and limit switch. Woks like new!
|
2 of 3 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsScrew drivers
CustomerDoug from Berkeley Springs WV
The ice and water dispenser would run on after the glass was removed
I am going to be completely honest here. This problem had persisted for months. I finally decided that I would buy all the associated parts and repair the unit hoping to cover the problem. Much to my surprise, after carrying out the repair, using the instructions provided by PartSelect, I still had the problem. I decided to remove and LUBRICATE the button which depresses the Limit Switch when you push a glass against the rubber membrane. Low and behold the problem was solved. The frig is nine years old, so I feel I may have prevented other problems in the future by replacing the three parts. It was a follow the directions sort of repair. I was very pleased with PartSelect response to my order (received it next day) with standard shipping.
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerDavid from Nesconset NY
Light wouln't go out in ice dispencer section
Extremely easy as I had alread taken the unit apart before except for the removal of the multipin connector from old board. Necessary to break the old board connector in order to get it off.
Might be nice for you to supply simple replacement instructions with the more expensive parts.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver
CustomerW. J. from Linden AL
Icemaker would not energize water solenoids, after it was replaced. Icemaker had hung keeping water on. Micro switch in fountain door had shorted out. I thought this may have ruined the control board.
after replacing control board, the water for ice maker still did not work. Took solenoid asy. out and the two cils for ice maker side were open. could not move wires to fountain solenoids because the fountain outlet to front was 3/8 inch and every thing else was 1/4 inch, so i had to order the solenoid assy. which is for coils. They
have also changed the tubing connections on the solenoids from compression screw on to insert
type once you push tubing in, there is no way
to remove it. reminds me of old electrical insert
connections which is a rip off.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
Customerrudy from furlong PA
Nothing would dispense. Indicator lights behaved eratically.
unplug refrigerator. pull off bottom tray. remove 2 cover screws. lift and pull cover. remove remove switch bd. screws. remove remove ribbon cable , top right. remove connector top left. reassemble in reverse.
|
1 of 12 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerPhillip from Minneapolis MN
Ice maker light stayed on.
Replaced the control board.
|