Clip-On Defrost Thermostat - 38 degrees

PartSelect Number PS2058709

It is a trip thermostat that will cut out at thirty-eight degrees Fahrenheit.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Fridge too warm.
  • Freezer section too warm.
  • Compare At

    $39.17
  • You Save

    $6.53
  • Your Price

    $32.64
In Stock
Order within the next 10 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 3 reviews What's this?
1-3 of 3
 

18 of 20 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver

CustomerKirk from Peralta NM

Defrost t-stat failed, defrost heater stayed energized and freezer could not pull down to temp

Unplugged refrigerator, removevd 4 hex head screws in rear panel of freezer. Gently pull panel forward and rotate panel to left side of freezer to expose coil. (If you have an ice maker you will have to remove this unit first) If no ice maker plastic plug will fall out of panel when you pull it forward. Set aside it aside.
Disconnect heater connections. (1) wire on each end of heater. Disconnected (2) wires that connect defrost t-stat. Removed (2) metal clips that hold defrost heater shield and defrost heater to coil..
pulled t-stat off of refrigerant line on right end and replaced with new. (It is only a little spring clip that is part of the t-stat) Replaced defrost heater. Reversed un-install procedure for metal clips and wiring. Gently plug wires in (do not pull on wires) Put rear panel back in place, put in the 4 screws , hand tighten only (just to snug) gently push on panel to make sure it is back as far as it will go..check screw tension again. Put plastic plug back in drain hole or re-install ice maker. Plug the refrigerator back in. This should not take you more than 30 min. max. I do not have an ice maker so it only took me 15 min.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 3 people found this instruction helpful

Parts Used

  • Clip-On Defrost Thermostat - 38 degrees

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerAmy from Pleasant Grove UT

Thermostat not working

Ok, first off, I am a girl-with absolutely no 'fix it skills" whatsover. My husband had pointed out the problem to me the second time the fridge started to get warm. I ordered the part (wrong one first time), then reordered the correct part. I emptied the freezer, defrosted the coils, installed the part. Put back together-all of it took about 15 minutes. I am still oh so very proud of myself.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 3 people found this instruction helpful

Parts Used

  • Clip-On Defrost Thermostat - 38 degrees

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver

CustomerRobert from Dewey OK

Ref. Not cooling

took cover off back of inside of freezer undone the thermostate and put back together

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3