2056755-1-S-Whirlpool-60100-1-Kickplate Clip
2056755-1-S-Whirlpool-60100-1-Kickplate Clip 2056755-2-S-Whirlpool-60100-1-Kickplate Clip 2056755-3-S-Whirlpool-60100-1-Kickplate Clip

Kickplate Clip

PartSelect Number PS2056755

Sold Individually. 2 are required to hold kickplate in place.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $3.24
  • You Save

    $.54
  • Your Price

    $2.70
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 3 reviews What's this?
1-3 of 3
 

2 of 5 people found this instruction helpful

Parts Used

  • Kickplate Clip

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerGaylon from Auburndale FL

Missing clips

I had to find a couple screws that would match the clips and kickplate. I screwed on the clips. The kickplate snapped on perfectly.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

  • Kickplate Clip

Level of DifficultyA Bit Difficult

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers, Socket set

CustomerPaul from Fort Wayne IN

Kickplate clip broke off

Reattaching the kickplate clip was easy, but the tab that holds in place was broken. It would slide back when the kickplate was installed. I fashioned a replacement tab out of a piece of 3/32 aluminum bent into a U with the hammer. To hold it in place I drilled and tapped one hole and used a 6-32 machine screw.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 4 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

Customerlane from silver spring MD

Broken bits

nothing exciting - I cut the retaining bar to the correct length, inserted the clips in the bar and pushed them in the holes - voilia, new bar in place.

The temp control discs were the same, push in place.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3